R0E0200F1EMU00 Renesas Electronics America, R0E0200F1EMU00 Datasheet - Page 35

• Manufacturer Part Number: R0E0200F1EMU00
• Description: DEV EMULATOR E200 MAIN BODY
• Manufacturer: Renesas Electronics America
• Series: SuperH®r
• Type: In-Circuit Emulatorr

Specifications of R0E0200F1EMU00

• Contents: Emulator Board, Cables, Software and Documentation
• For Use With/related Products: SH7080
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

3.1
1. When the emulator system is initiated, it initializes the general registers and part of the control
Table 3.1 Register Initial Values at Emulator Link Up
Register
R0 to R14
R15 (SP)
PC
SR
GBR
VBR
TBR
MACH
MACL
PR
Note: When a value of the interrupt mask bit in the SR register is changed in the [Registers]
2. The emulator uses the H-UDI; do not access the H-UDI.
3. Low-Power States (Sleep, Software Standby, and Module Standby)
Section 3 Software Specifications when Using the SH7286,
registers as shown in table 3.1. The initial values of the MCU are undefined. When the
emulator is initiated from the workspace, a value to be entered is saved in a session.
⎯ When the emulator is used, the sleep state can be cleared with either the clearing function
⎯ The memory must not be accessed or modified in software standby state.
⎯ Do not stop inputting the clock to the H-UDI module by using the module standby
or with the [STOP] button, and a break will occur.
function.
window, it is actually reflected in that register immediately before execution of the user
program is started. It also applies when the value is changed by the REGISTER_SET
command.
Differences between the MCU and the Emulator
SH7285, and SH7243
Emulator at Link Up
H'00000000
Value of the SP in the power-on reset vector table
Value of the PC in the power-on reset vector table
H'000000F0
H'00000000
H'00000000
H'00000000
H'00000000
H'00000000
H'00000000
Rev. 4.00 Feb. 18, 2009 Page 27 of 64
REJ10J1662-0400