HS7047KCI02H Renesas Electronics America, HS7047KCI02H Datasheet - Page 5

• Manufacturer Part Number: HS7047KCI02H
• Description: DEV EMULATOR E10A-PCI
• Manufacturer: Renesas Electronics America
• Series: SuperH®r
• Type: In Circuit Debuggerr

Specifications of HS7047KCI02H

• Contents: E10A-LITE, Cable and CD-ROM
• For Use With/related Products: SH7047
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

To connect the E10A emulator (hereafter referred to as the emulator), the H-UDI port connector
must be installed on the user system to connect the user system interface cable. When designing
the user system, refer to the recommended circuit between the H-UDI port connector and the
MCU. In addition, read the E10A emulator user's manual and the hardware manual for the related
MCU.
Table 1.1 shows the type numbers of the E10A emulator, the corresponding connector types, and
the use of AUD function.
Table 1.1 Type Number, AUD Function, and Connector Type
Type Number
HS7047KCM02H, HS7047KCI02H
HS7047KCM01H, HS7047KCI01H
The H-UDI port connector has the 36-pin and 14-pin types as described below. Use them
according to the purpose of the usage.
1. 36-pin type (with AUD function)
2. 14-pin type (without AUD function)
1. Connecting the E10A Emulator with the User System
The AUD trace function is supported. A large amount of trace information can be acquired in
realtime. The RAM monitoring function, which accesses (reads or writes) the memory
contents during program execution, is also supported.
The user cannot use the AUD trace function because only the H-UDI function is supported.
For tracing, only the internal trace function is supported. Since the 14-pin type connector is
smaller than the 36-pin type (1/2.5), the area where the connector is installed on the user
system can be reduced.
Connector
36-pin connector
14-pin connector
AUD Function
Available
Not available
1