HS3048BTCM01H Renesas Electronics America, HS3048BTCM01H Datasheet - Page 152

• Manufacturer Part Number: HS3048BTCM01H
• Description: ON CHIP DEBUG EMULATOR
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of HS3048BTCM01H

• Contents: E10T-USB, Cable and CD-ROM
• For Use With/related Products: H8/3048B
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Notes on Setting the Break Condition:
1. When [Go to cursor], [Step In], [Step Over], or [Step Out] is selected, the settings of Break
2. Setting of Break Condition 1 is disabled when an instruction to which a software breakpoint
3. When step over function is used, the settings of software breakpoint and Break Condition 1 are
6.4.3
1. When an odd address is set, the address is rounded down to an even address.
2. A software break is accomplished by replacing instructions. Accordingly, it can be set only to
3. During step execution, a software breakpoint is disabled.
4. A condition set at Break Condition 1 is disabled immediately after starting execution when an
5. When execution resumes from the breakpoint address after the program execution stops at the
6.
6.4.4
126
Condition 1 are disabled.
has been set is executed.
disabled.
the flash memory or RAM area. However, a software break cannot be set to the following
addresses:
instruction at a software breakpoint is executed. A break does not occur even if a condition of
Break Condition 1 is satisfied immediately after starting the execution.
software breakpoint, single-step execution is performed at the address before execution
resumes. Therefore, realtime operation cannot be performed.
The trace function in the H8/3048F-ONE E10T emulator uses the branch-instruction trace
function in the MCU. It displays the branch-source address or the mnemonic, and operand can
be acquired in realtime.
Settings of software breakpoint and Break Condition 1 are invalid while the STEP OVER
function is being used.
An area other than flash memory or RAM
An instruction in which Break Condition 1 is satisfied
Notes on Setting the [Breakpoint] Dialog Box
Trace Function