45214 Parallax Inc, 45214 Datasheet - Page 88

• Manufacturer Part Number: 45214
• Description: PROGRAMMER SX-KEY USB
• Manufacturer: Parallax Inc
• Type: In-System Programmerr

Specifications of 45214

• Contents: Programmer Board
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: SX MCUs
• For Use With: 70002PAR - GUIDE PROG THE SX MICRO -DAUBACH45111 - MANUAL FOR SX-KEY/BLITZ VER. 2.028138 - BOARD DEV PROFESSIONAL
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: Q4044550

10 SX Special Features and Coding Tips
10.2.1 Port Direction
Each of the I/O pins in each of the ports can be configured to an input or output direction by writing to
the appropriate tristate register (TRIS_A, TRIS_B, TRIS_C, TRIS_D and TRIS_E). The default I/O pin
direction is input. I/O pin direction configuration is usually done once, near the start of code, however,
the pin directions can be changed multiple times at any place in the code.
To configure the direction of the I/O pins to inputs or outputs:
The following code snippet demonstrates this:
If the logic-level of output pins are expected to begin at a certain state (0 or 1), care should be taken to
set the output latch appropriately before setting the pin’s direction to output. Failing to do so may result
in a momentary glitch on the pin during initialization. For example, if all output pins were expected to
begin in a low state (0), insert the following lines above the previous code snippet:
Page 88 SX-Key/Blitz Development System Manual 2.0 Parallax, Inc.
1) Set the MODE register to $0F (the default value at startup).
2) Use the port configuration instruction to set the individual directions of each I/O pin within each
port. A high bit (1) sets the corresponding pin to input mode and a low bit (0) sets the pin to out-
put mode.
; Direction Configuration
;
MODE $0F
MOV
MOV
MOV
* Port C not available on SX20 devices, Port D and E only available on SX48/52 devices.
NOTE: More options exist for the SX48/52 parts. See chapter 15.4.2 for details.
$07 - $00
MODE
$0D
$0C
$0A
$0F
$0E
$0B
$09
$08
!ra,#%0000
!rb,#%11110000 ; Port B bits 4-7 to input, bits 0-3 output
!rc,#%00001111 ; Port C bits 4-7 to output, bits 0-3 input
TRIS_A
Port A
LVL_A
PLP_A
; Set Mode to allow Direction configuration
; Port A bits 0-3 to output
Table 20 - MODE Register Settings
Swap W with WKPEN_B
Swap W with COMP_B
WKEN_B
WKED_B
Port B
TRIS_B
LVL_B
PLP_B
ST_B
Port C*
TRIS_C
PLP_C
LVL_C
ST_C
Port D*
TRIS_D
LVL_D
PLP_D
ST_D
Port E*
TRIS_E
LVL_E
PLP_E
ST_E