FS2009(SAM7) Equinox Technologies, FS2009(SAM7) Datasheet - Page 4

• Manufacturer Part Number: FS2009(SAM7)
• Description: ISP MULTI PROJECT AT91SAM7 USB
• Manufacturer: Equinox Technologies
• Series: FS2009r
• Type: Portable Production ISPr

Specifications of FS2009(SAM7)

• Contents: Programmer, Software, Cables and Documentation
• Ic Product Type: Programmer, In-Circuit
• Supported Families: AT91SAM7 A, S, SE
• Features: Supports Standalone Operation, Robust I/O Driver Stage, Very Fast Programming Speed
• Rohs Compliant: Yes
• For Use With/related Products: ATMEL AT91SAM7 devices
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 483-1019

Equinox Products Page - FS2009 - Portable multi-project ISP Programmer for Atmel AT91SAM7 Microcontroll...
http://www.equinox-tech.com/products/details.asp?ID=1312
The Programmer supports the following powering options:
The Programmer comes with a 9V DC Power Supply which is regulated down to +5.0V inside the
programmer.
The FS2009(SAM7) supports fast programming of Target Devices via the JTAG algorithm.
The programmer is capable of performing a multi-project Programming Sequence in Standalone
Mode as follows:
This powerful functionality allows the programmer to be used as part of an In-Circuit Test procedure
where the Target Firmware must be allowed to execute in order to eg. calculate some calibration
values. The programmer initially programs some 'Test Firmware' into the Target Device and then
allows the Target to run this firmware and waits for this firmware to finish executing. The real
'Production Firmware' is then programmed into the Target Device.
This product supports devices from the families listed below:
Atmel Corporation:
The following are available as chargeable upgrades: JTAG In-System Programming support
for the Atmel ATmega AVR Family and 24Cxxx - Serial I2C EEPROM Memory Device Library.
See [Upgrades] tab.
Please note:
Not all devices may be supported within a family.
Please see the
Programmer / Target System - Power Supply Options
CE / FCC / RoHS Approved Product
Spare Programmer I/O pins
Fast Programming Times
Standalone Mode - Program -> Test -> Re-Program
Device Support (by family)
Ordering Information...
Target System can supply power to the programmer: 3.0 - 5.0V @ 50mA
Programmer can supply power to the Target System: 5.0V @ 300mA
Programmer and Target System can be Independently Powered
The FS2009 is a CE / FCC and RoHS approved product
In SPI mode, there are 2 x Spare I/O pins for custom use
In UART mode, there is 1 x Spare I/O pins for custom use
The spare I/O pin(s) can be used for controlling circuitry on the user Target System including
Chip Selects, additional RESET control lines, Watchdog Timers etc.
Program Test Firmware
Execute Target Firmware
Wait for Target Firmware to finish
Program Production Firmware
AT91SAM7A - ARM7 FLASH Microcontroller
AT91SAM7L (Low Power) Series - ARM7 FLASH Microcontroller
AT91SAM7S - ARM7 FLASH Microcontroller
AT91SAM7SE - ARM7 FLASH Microcontroller
Detailed Device Support List
FS2009 - Portable multi-project ISP Programmer for Atmel
AT91SAM7 Microcontrollers
for a list of all devices which the product supports.
Page 4 of 5
2/4/2009