FS2009(AVR-JTAG) Equinox Technologies, FS2009(AVR-JTAG) Datasheet - Page 4

• Manufacturer Part Number: FS2009(AVR-JTAG)
• Description: ISP MULTI PROJECT AVR JTAG USB
• Manufacturer: Equinox Technologies
• Series: FS2009r
• Type: Portable Production ISPr

Specifications of FS2009(AVR-JTAG)

• Contents: Programmer, Software, Cables and Documentation
• For Use With/related Products: ATMEL AVR JTAG devices
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 483-1018

Equinox Products Page - FS2009 - Portable multi-project USB ISP Programmer for Atmel ATmega Microcontr...
http://www.equinox-tech.com/products/details.asp?ID=1313
The Programmer supports the following powering options:
The Programmer comes with a 9V DC Power Supply which is regulated down to +5.0V inside the
programmer.
The FS2009(AVR-JTAG) supports programming of the Atmel ATmega AVR Microcontroller Family
using the JTAG algorithm. This allows the FS2009 to program the ATmega devices at high speed via
the JTAG port of the Target Device.
The advantages of JTAG In-System Programming are:
The FS2009 is a CE / FCC and RoHS approved product.
The FS2009 (AVR-JTAG) supports fast programming of Target Devices via the JTAG algorithm.
The programmer is capable of performing a multi-project Programming Sequence in Standalone
Mode as follows:
This powerful functionality allows the programmer to be used as part of an In-Circuit Test procedure
where the Target Firmware must be allowed to execute in order to eg. calculate some calibration
values. The programmer initially programs some 'Test Firmware' into the Target Device and then
allows the Target to run this firmware and waits for this firmware to finish executing. The real
'Production Firmware' is then programmed into the Target Device.
Programmer / Target System - Power Supply Options
JTAG ISP Support for Atmel ATmega AVR Microcontrollers
CE / FCC / RoHS Approved Product
Spare Programmer I/O pins
Fast Programming Times
Standalone Mode - Program -> Test -> Re-Program
Device Support (by family)
Target System can supply power to the programmer: 3.0 - 5.0V @ 50mA
Programmer can supply power to the Target System: 5.0V @ 300mA
Programmer and Target System can be Independently Powered
Much faster programming times (up to x4 times faster than SPI)
JTAG port can also be used as a 'Debug Port' during product development
In SPI mode, there are 2 x Spare I/O pins for custom use
In UART mode, there is 1 x Spare I/O pins for custom use
The spare I/O pin(s) can be used for controlling circuitry on the user Target System including
Chip Selects, additional RESET control lines, Watchdog Timers etc.
Program Test Firmware
Execute Target Firmware
Wait for Target Firmware to finish
Program Production Firmware
Page 4 of 5
2/4/2009