EPSILON5-A1 Equinox Technologies, EPSILON5-A1 Datasheet - Page 26

• Manufacturer Part Number: EPSILON5-A1
• Description: ISP PORTABLE PROGRAMMER USB
• Manufacturer: Equinox Technologies
• Series: Epsilon5r
• Type: Portable ISPr

Specifications of EPSILON5-A1

• Contents: Programmer, Software, Cables and Documentation
• Ic Product Type: In-Circuit Programmer
• Features: 2Mbits Of On-Board Non-Volatile FLASH Memory For User Project Storage
• Interface Type: JTAG
• Mcu Supported Families: ATmega And AT91SAM7
• Mpu Supported Families: AVR
• Rohs Compliant: Yes
• External Depth: 31mm
• Height: 189mm
• Length: 80mm
• For Use With/related Products: ATMEL AT89S, AVR, AT91SAM7, NXP P89C51Rx2 P89C66x, Zensys, Serial EEPROM's
• Other names: 483-1000

1.6.2 Programming Interface to Target Device
The programmer supports the following programming interfaces to the Target Device:
#
1
2
3
4
Please refer to section 4 for information on which ISP Header to use for the required programming
interface.
EPSILON5 MKII Programmer - User Guide V1.10 – 10th July 2006
Programming
Interface
LV SPI
HV SPI (+12V
Vpp)
UART Boot
Loader
JTAG
(Atmel AVR)
Family
AT89S
AT90S
ATmega
ATtiny
Zensys
ATtiny
T89C51Rx2
P89X51Rx2
ATmega
Description / Comment
Atmel Low Voltage Serial Programming Mode
Atmel High Voltage Serial Programming Mode
Atmel / Philips UART Boot Loader Interface
Atmel ATmega AVR – JTAG ISP Interface
•
•
•
•
•
•
•
•
•
•
•
Atmel 3-wire SPI interface (SCK, MOSI, MISO )
Target Device RESET
Works at target voltage (no Vpp required)
Atmel 4-wire SPI Interface (SCK, MOSI, MISO, MOSI2)
+12V Vpp is applied to the RESET pin to enter High
Voltage Serial Programming Mode
Requires different connections to Target Device
compared with LV SPI.
Requires all pins of target device to be accessible by the
programmer.
Uses RXD, TXD, PSEN, and Target Device RESET pin
TTL Levels from programmer to Target System
Uses same connector as Atmel JTAG ICE
A chargeable license upgrade is required to enable the
ATmega JTAG ISP libraries.
15