DEMOKIT-KA1 Renesas Electronics America, DEMOKIT-KA1 Datasheet - Page 40

• Manufacturer Part Number: DEMOKIT-KA1
• Description: KIT DEMO 78K0S KA1 UPD78F9222
• Manufacturer: Renesas Electronics America

Specifications of DEMOKIT-KA1

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

34
• Clicking OK saves the settings selected on the Standard and Advance tabs and closes the
• Clicking Cancel closes the dialog box without saving the settings selected on the Standard
• Parameter file holds parameters and timing data required to rewrite the target device’s flash
• The Look in: list displays a list of available .prm files. Select the one you want to open and
• The Port list displays the channels available for communication between the Low Pin
• The Speed list enables you to select a rate for the selected communication channel.
• The Supply oscillator box is used to select a clock that determines the programming
dialog box.
and Advance tabs.
memory. Do not modify the data in the parameter file because the data is related to the
guarantee of rewrite data. The parameter file is protected by the checksum function. If the
checksum result indicates an error, PG-LPC does not accept the parameter file.
then click Open. The communication interface to the device box is used to select a channel
for communication between the Low Pin Count—Do it! board and host machine.
Count—Do it! board and host machine. Note: Selectable ports can be checked using the
Device Manager. For details, refer to “Confirmation of USB Driver Installation.”
frequency and data transfer rate. Selecting a frequency sets the clock frequency of the target
system, which can vary from one device to another. Be sure to check the specifications for
the device used before making a selection. Selecting a multiply rate specifies the division
rate or multiplication rate of the target device. If the target device has an on-chip phase-
Figure 38. Device Setup: Parameter File Selection
Figure 40. Host Connection Box
Figure 39. Open Dialog Box