EDK2612 Renesas Electronics America, EDK2612 Datasheet - Page 3

• Manufacturer Part Number: EDK2612
• Description: DEV EVALUATION KIT H8S/2612
• Manufacturer: Renesas Electronics America
• Series: H8®r
• Type: MCUr

Specifications of EDK2612

• Contents: 2G (Second-generation) Evaluation Board, HEW debugger support, Cable and CD-ROM
• For Use With/related Products: H8S/2612
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Before applying power to the board, please ensure that the jumpers fitted to CJ4
and CJ5 are set as follows (Pin 1 is indicated by an arrow on the silk-screen):
The HDI monitor will need to be programmed into the microcontroller FLASH to allow you to debug your code. Unless this
file is resident in the microcontroller no debugging can be performed with HDI.
The Monitor allows user code to be downloaded and run from RAM, rather than needing to re-program the Microcontroller
FLASH when the user code changes.
•
•
•
•
•
•
•
•
•
•
Hitachi Micro Systems
Programming the Board
Start FDT by using the Start Menu to navigate to
and select "Flash Development Toolkit 1.5".
When the "Welcome!" dialog box for FDT is
displayed, click
workspace as the Quick Programming method is
sufficient.
Load the file HDIM2612M7.mot by selecting the
"File", "Open" menu item, and navigate to the
HDI – M directory on the CD.
Once the file has been loaded into FDT, it is
visible in the work area.
Select the "Image", "Download Image" menu item to
open the "FLASH Controller" dialog box.
Set the "Target device" option to H8S/2612F.
Ensure the correct COM Port is selected.
Select "BOOT" mode.
Set the "Select Interface" option to Direct Connection.
Press the BOOT switch on the EDK.
Click "Connect" to download the FLASH kernel.
When the download is complete, the message "Connection
complete" will be displayed in the Status view.
Click "Download file HDIM2612M7.mot to device" to
download your program file image.
The message "Image successfully written to device" will
be displayed in the Status view.
Click "Disconnect" to free the COM Port for use by the
debugger. Close FDT, then press the RESET button on the
EDK.
CJ4 (User Configuration)
CJ5 (Mode Configuration)
"Cancel". Do not create a
2 – 3
1 – 2
PIN CONNECTIONS
5 – 6
4 – 5
7 – 8
–
10 – 11
–
Hitachi Micro Systems
D - Type
9 - Way
Switch
Reset
BOOT
Switch
CJ4
CJ5
D004317_11_v02
3