R0K521134S000BE Renesas Electronics America, R0K521134S000BE Datasheet - Page 16

• Manufacturer Part Number: R0K521134S000BE
• Description: KIT EVAL STARTER FOR R8C/13
• Manufacturer: Renesas Electronics America
• Series: Renesas Starter Kits (RSK)r
• Type: MCUr

Specifications of R0K521134S000BE

• Contents: CPU Board, LCD Display Module, E8 Emulator, Cable, QuickStart Guide and CD-ROM
• For Use With/related Products: R8C/13
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

The RSK supports Boot mode and Single chip mode.
Details of programming the FLASH memory is described in the R8C/13 Group Hardware Manual.
7.1. Boot mode
The boot mode settings for this RSK are shown in Table 7-1: Boot Mode pin settings below:
The software supplied with this RSK supports Boot mode using an E8 and HEW only. However, hardware exists to enter boot mode
manually, do not connect the E8 in this case. Press and hold the SW1/BOOT. The mode pin is held in its boot state while reset is pressed
and released. Release the boot button. The BOOT LED will be illuminated to indicate that the microcontroller is in boot mode.
When neither the E8 is connected northe board is placed in boot mode as above, the Mode pin is pulled high by a 100k resistor.
When an E8 is used the Mode pin is controlled by the E8.
7.2. Single chip mode
Because the Mode pin is pulled high, this RSK will always boot in Single Chip mode when the E8 is not connected and the boot switch is not
depressed. Refer to R8C/13 Group Hardware Manual for details of Single chip mode.
MODE
Low
MODE
High
Chapter 7. Modes
Table 7-2: Single Chip Mode pin settings
Table 7-1: Boot Mode pin settings
LSI State after Reset End
Boot Mode
LSI State after Reset End
Single Chip Mode
12