CML12C32SLK Freescale Semiconductor, CML12C32SLK Datasheet - Page 18

• Manufacturer Part Number: CML12C32SLK
• Description: KIT STUDENT LEARNING 16BIT HCS12
• Manufacturer: Freescale Semiconductor
• Type: MCUr

Specifications of CML12C32SLK

• Contents: *
• For Use With/related Products: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

C M L - 1 2 C 3 2
3. Verify the logic power source. Measure +5VDC between the GND and +5V connections
4. Make sure that the RESET line is not being held low. Measure the voltage level at the
5. Verify the communications port is working by substituting a known good serial device or by
6. Ensure NO_AUTO jumper is installed. This will prevent any loaded program from execut-
7. Disconnect all external connections to the board except serial cable and the wall plug.
8. Verify the presence of a 16MHz clock signal at the EXTAL input pin.
9. Contact
Tips and Suggestions
Following are a number of tips, suggestions, and answers to commonly asked questions that
will solve many problem users have with the CML-12C32 development system. You can
download the latest software from the Support section of our web page at:
Utilities
• Make sure all jumpers are set correctly if trying to program memory or start the utilities.
• Make sure the serial cable is bi-directional and connected securely to both the PC and
• Make sure the serial cable is connected to the correct serial port.
• Make sure the power is supplied to the board. Only use a 9 volt, 200mA minimum wall
• Make sure you load your code to an address space that actually exists. See the Mem-
• If debugging under embedded monitor, make sure you're not over-writing reserved in-
• If running in a multi-tasking environment (such as Windows) close all programs in the
the board.
adapter, or DC power supply set to provide 9V output to the board. If applicable, make
sure the power strip is turned on.
ory Map if you’re not sure. MCU mode (single chip or expanded) changes the memory
map.
ternal SRAM.
background to reduce the potential for conflicts.
connector.
on the TB1 power connector. If the +VIN supply is present and the +5V output is not pres-
ent, immediately disconnect power from the board.
email for instructions; provide board name and problem.
RESET* signal on the BUS_PORT connector.
doing a loop back diagnostic.
ing at power-on or RESET.
describe problem.
www.axman.com
[e-mail]
by email for further assistance. Provide board name and
18
Contact
[e-mail]
J U L Y
2 6 ,
2 0 0 4
by