101-1147 Rabbit Semiconductor, 101-1147 Datasheet - Page 3

• Manufacturer Part Number: 101-1147
• Description: KIT RIO PROGRAM I/O
• Manufacturer: Rabbit Semiconductor
• Series: Rabbit® RIO™r
• Type: MPU Moduler

Specifications of 101-1147

• Contents: RabbitCore Module, Dev. Board, AC Adapter, Cable and Dynamic C® CD-Rom
• Processor To Be Evaluated: RCM4100
• Data Bus Width: 8 bit
• Interface Type: SPI
• Silicon Manufacturer: Rabbit
• Silicon Family Name: Rabbitcore
• Kit Contents: Board
• Features: Multiple Communication Interfaces
• Development Tool Type: Hardware / Software - Dev Kit (Dev Tool)
• Rohs Compliant: Yes
• For Use With/related Products: RCM4100
• Lead Free Status / RoHS Status: Vendor undefined / Vendor undefined

Connect the other end of the programming cable to a COM port on your PC.
5. Connect Power
Once all the other connections have been made, you can connect power to the Prototyping Board.
First, prepare the AC adapter for the country where it will be used by selecting the appropriate plug.
The RIO Programmable I/O Kit presently includes Canada/Japan/U.S., Australia/N.Z., U.K., and
European style plugs. Snap in the top of the plug assembly into the slot at the top of the AC adapter as
shown in Figure 3, then press down on the plug until it clicks into place.
Connect the AC adapter to 3-pin header J1 on the Prototyping Board as shown in Figure 3 above. The
connector may be attached either way as long as it is not offset to one side—the center pin of J1 is
always connected to the positive terminal, and either edge pin is ground.
Plug in the AC adapter. The power LED on the Prototyping Board above the power connector at J1
should light up. The RCM4110 and the Prototyping Board are now ready to be used.
NOTE: Be sure to use the programming cable (part number 101-0542) supplied with the RIO
NOTE: Some PCs now come equipped only with a USB port. It may be possible to use an RS-232/
NOTE: If you need to reset the RCM4110, disconnect, then reconnect the power supply.
Programmable I/O Kit—the programming cable has blue shrink wrap around the RS-232 con-
verter section located in the middle of the cable. Programming cables with red or clear shrink
wrap from other Rabbit Semiconductor kits are not designed to work with RCM4110 modules.
USB converter (Part No. 540-0070) with the programming cable supplied with the RIO Pro-
grammable I/O Kit. Note that not all RS-232/USB converters work with Dynamic C.
power connector
Figure 3. Prototyping Board and Programming Cable Setup
3-pin