101-1156 Rabbit Semiconductor, 101-1156 Datasheet - Page 89

• Manufacturer Part Number: 101-1156
• Description: KIT DEVELOPMENT INT'L RCM4200
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore 4000r
• Type: MPU Moduler

Specifications of 101-1156

• Contents: RabbitCore Module, Dev. Board, AC Adapter, Cable and Dynamic C® CD-Rom
• Processor To Be Evaluated: Rabbit 4000
• Data Bus Width: 8 bit
• Interface Type: Ethernet
• Silicon Manufacturer: Rabbit Semiconductor
• Core Architecture: Rabbit 4000
• Kit Contents: RCM4200 Module, Prototyping Board, AC Adapter, Cable, Dynamic C CD-ROM, Getting Started Instructions
• For Use With/related Products: RCM4200
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

6.4.2 How to Set Up your Computer for Direct Connect
Follow these instructions to set up your PC or notebook. Check with your administrator if
you are unable to change the settings as described here since you may need administrator
privileges. The instructions are specifically for Windows 2000, but the interface is similar
for other versions of Windows.
1. Go to the control panel (
2. Select the network interface card used for the Ethernet interface you intend to use (e.g.,
3. Now select the
4. Click
User’s Manual
Network icon.
TCP/IP Xircom Credit Card Network Adapter
Depending on which version of Windows your PC is running, you may have to select
the “Local Area Connection” first, and then click on the “Properties” button to bring up
the Ethernet interface dialog. Then “Configure” your interface card for a “10Base-T
Half-Duplex” or an “Auto-Negotiation” connection on the “Advanced” tab.
click on “Properties” to assign an IP address to your computer (this will disable “obtain
an IP address automatically”):
TIP: If you are using a PC that is already on a network, you will disconnect the PC from
NOTE: Your network interface card will likely have a different name.
IP Address : 10.10.6.101
Netmask : 255.255.255.0
Default gateway : 10.10.6.1
<OK>
that network to run these sample programs. Write down the existing settings before
changing them to facilitate restoring them when you are finished with the sample pro-
grams and reconnect your PC to the network.
or
IP 10.10.6.101
Netmask
255.255.255.0
IP Address
<Close>
Direct Connection PC to RCM4200 Module
Start > Settings > Control Panel
to exit the various dialog boxes.
tab, and check
User’s PC
Ethernet
crossover
cable
Specify an IP Address
) and click on the “Properties” button.
RCM4200
System
), and then double-click the
, or select TCP/IP and
83