R0K571242S000BE Renesas Electronics America, R0K571242S000BE Datasheet - Page 5

• Manufacturer Part Number: R0K571242S000BE
• Description: KIT DEV RSK SH7124
• Manufacturer: Renesas Electronics America
• Series: Renesas Starter Kits (RSK)r
• Type: MCUr

Specifications of R0K571242S000BE

• Contents: CPU Board, LCD Display Module, E8 Emulator, Cable, QuickStart Guide and CD-ROM
• For Use With/related Products: SH7124
• Lead Free Status / RoHS Status: Not applicable / Not applicable

28. Click on the ‘Build’ icon to compile, assemble and link the project.
4. Programming and Debug
29. Select the “SessionSH7125Series_E10A_USB_SYSTEM” session in the right
30. Click the <Connect> button on the debug toolbar.
31. The ‘Select Emulator mode’ dialog will appear. Select the device “SH7124” and the “E10A-USB Emulator”
First use of the E10A module
32. The ‘Please choose driver’ dialog will be shown. Click <OK>
33. The ‘Driver Details’ dialog will be shown, please select “Renesas E-Series USB Driver” as illustrated. The
34. The Firmware setup dialog will be shown warning you not to disconnect the USB cable until the firmware
35. The firmware will be downloaded to the E10A module; this will take a few moments.
36. A dialog will be shown asking you to reset the user system and press <Enter>, please do so.
37. The ‘System Clock’ dialog will be shown, enter ‘10.00’ MHz and click <OK>.
38. The ‘ID code’ dialog will appear, enter “0000E10A” for the ID code and check the “New ID code” tick-box and click <OK>.
39. HEW will connect to the target and show “Connected” in the ‘Output’ view.
40. Right click on the download module listed in the left hand pane and select
41. Click the ‘Reset – Go’ button.
42. The code will now be downloaded (this will take a moment or two) and will
43. Click the ‘Stop’ button.
hand drop down list on the tool bar.
radio button and click <OK>.
If this isn’t the first time you have used the E10A module with this RSK, please skip to step 36.
‘Interface’ and ‘Channel’ items will be automatically populated. Click <Close>.
download is complete. Click <OK>.
Please do not disconnect the E10A from the host during download, doing so is likely to damage
the E10A module.
‘Download’.
The code will not yet be downloaded to the microcontroller.
then run. You will see the LEDs flash on the board, the rate of flashing can be adjusted using the Analog Adjust control.
The code will stop and the source code opened at the current program counter.
D007094_11_S01_V05