SKP38024 Renesas Electronics America, SKP38024 Datasheet - Page 4

• Manufacturer Part Number: SKP38024
• Description: KIT STARTER FOR H8/38024
• Manufacturer: Renesas Electronics America
• Series: H8®r
• Type: MCUr

Specifications of SKP38024

• Contents: SKP Board, In-Circuit Debugger/Programmer, Target Cable, USB Cable and SKP CD-ROM
• For Use With/related Products: H8/38024
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Warning: Applying a higher voltage than 3.3V via the
Debug
5.0 Next Steps
After you have completed this QuickStart procedure, please review the tutorials that came with the kit.
The tutorials will help you understand and jumpstart the software development process using Renesas’
development tools.
You can view the tutorials from the Start Menu via Start > (All) Programs > Renesas > SKPH8Tiny > All
Documents.
6.0 Renesas H8S, H8/300 Compiler
Included in the SKP is the Evaluation Version of the H8S, H8/300 C-compiler. The limitations are:
The full licensed version is available from your Renesas supplier.
SKP38024 StarterKit Plus Quick Start Guide, rev. 0.3
g.) Select “Power supply is carried out”. With this
h.) Enter “9.8034” MHz in the System clock
i.) Enter “00E8” for ID code and click <OK>
j.) Under
k.) Click on the “Reset-Go” icon
k.) Click on the “Reset-Go” icon
l.) Click on the “Stop” icon
m.) From the “File” pull-down menu, select “Exit”.
selection, the E8 will provide power to the SKP
board.
window and click <OK> (F
(F
“Download Modules > All Download Modules”,
or right click on the “.abs” file in the left
(workspace) window.
(workspace) window.
program. The red “USR2” LED will start to
blink. After an approximately 10 second delay
the LCD will start to display alternating
patterns.
program. Code execution will stop and the
source code window display the code at the
current program counter address.
If requested to save workspace and/or session,
click <Yes>.
1. No support or warranty without the purchase of a full license.
2. After 60 days, code size is limited to 64 kBytes.
Connector
ii.) The red “Power”, “USR1” and “USR2”
i.) Select “3.3V”, click <OK> (Figure 9).
igure 11
LEDs will turn on.
the
).
k on the “.abs” file in the left
“Debug”
may
damage
menu
igure 10
your
item,
).
to halt the
to start the
board.
select
Figure 9: Power Supply Selection
Figure 10: System Clock
Figure 11: ID Code Window
Page 4 of 5