DEMO908GZ60E Freescale Semiconductor, DEMO908GZ60E Datasheet - Page 7

• Manufacturer Part Number: DEMO908GZ60E
• Description: BOARD DEMO FOR 908GZ60 MCU
• Manufacturer: Freescale Semiconductor
• Series: HC08GRr
• Type: MCUr

Specifications of DEMO908GZ60E

• Design Resources: DEMO908GZ60E Schematic
• Contents: Board, Cable, CD
• Processor To Be Evaluated: 908GZ
• Data Bus Width: 16 bit
• Interface Type: RS-232
• For Use With/related Products: 68HC908GZ60
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

D E M O 9 0 8 R G 6 0
3. Set module options for RUN Mode:
4. Power On the Module. Application will begin to execute.
MON08 DEBUG MODE on COM
MON08 Monitor Mode operates the HC08 internal MON08 debug monitor from Power-On.
This mode is accessible by setting Module options or by applying a supporting development
cable to the Debug Port. For Debug cable application, the state of the MON_EN option jump-
ers is DON’T CARE. The COM_EN option jumper should be set to the 2-3 position. The
VTST_EN jumper may be required. Refer to the MON08 Configuration section of this docu-
ment for further details.
MON08 Debug Mode on COM:
1. Configure PWR_SEL option for input supply to power the module. If supply is via J1 con-
2. Connect one end of the supplied 9-pin serial cable to a free COM port on the PC. Connect
3. Install and launch the PC Hosting software for the MON08 communication interface. This
4. Set the Module options for MON08 Debug Mode:
5. Apply +9VDC minimum power to the module. This may be applied by TB1 or through J1.
6. Hosting development software will establish MON08 communication now.
nection, install module on J1 external connection in powered down condition. Note that the
VTST_EN option requires 9VDC minimum applied at TB1 to function correctly.
the other end of the cable to the COM port connector on the DEMO908GZ60 module.
may be a C compiler with IDE and MON08 communication or another MON08 debug host-
ing type software.
VTST_EN
MON_EN
COM_EN
RUN/LOAD
USER_EN
VTST_EN
MON_EN
COM_EN
USER_EN
2-3 (COM position)
ON / Installed on both pins
1-2 (DEBUG position)
Off / open / idle
Off/ open / idle
Set to RUN
Enabled as needed for application operation
ON / Installed on both pins (required if the Reset
vector is not erased in the flash memory)
Enabled as needed for application operation
The following settings configure the DEMO908GZ60 module for
7
A U G U S T
6 ,
2 0 0 4