TOOLSTICKSK Silicon Laboratories Inc, TOOLSTICKSK Datasheet - Page 5

• Manufacturer Part Number: TOOLSTICKSK
• Description: KIT STARTER TOOLSTICK
• Manufacturer: Silicon Laboratories Inc
• Series: ToolStickr
• Type: MCUr

Specifications of TOOLSTICKSK

• Contents: Base Adapter, C8051F330 Daughter Card and USB Cable
• Interface Type: USB
• Operating Supply Voltage: 2.7 V to 3.6 V
• Accessory Type: Starter Kit Adapter
• Convert From: USB
• Convert To: Daughter Board
• Development Tool Type: Hardware - Daughter Card
• Mcu Supported Families: ToolStick C8051F330
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: C8051F300
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With: C8051F330
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Contains lead / RoHS non-compliant
• Other names: 336-1348

ToolStick-F330DC
5.4. Keil uVision2 and uVision3 Silicon Laboratories Drivers
As an alternative to the Silicon Laboratories IDE, the uVision debug driver allows the Keil uVision2 and uVision3
IDEs to communicate with Silicon Laboratories on-chip debug logic. In-system Flash memory programming
integrated into the driver allows for rapidly updating target code. The uVision2 and uVision3 IDEs can be used to
start and stop program execution, set breakpoints, check variables, inspect and modify memory contents, and
single-step through programs running on the actual target hardware.
For more information, please refer to the uVision driver documentation. The documentation and software are
available from the Downloads webpage (www.silabs.com/mcudownloads).
5.5. ToolStick Terminal
The ToolStick Terminal program provides the standard terminal interface to the target microcontroller's UART.
However, instead of requiring the usual RS-232 and COM port connection, ToolStick Terminal uses the USB
interface of the ToolStick Base Adapter to provide the same functionality.
In addition to the standard terminal functions (send file, receive file, change baud rate), two GPIO pins on the target
microcontroller can be controlled using the Terminal for either RTS/CTS handshaking or software-configurable
purposes (see the demo software for an example).
See Section 6.8 for more information on using ToolStick Terminal. The software is available on the ToolStick
webpage (www.silabs.com/toolstick).
Rev. 0.3
5