101-1050 Rabbit Semiconductor, 101-1050 Datasheet - Page 15

• Manufacturer Part Number: 101-1050
• Description: KIT DEV RABBITCORE RCM3750
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore 3000r
• Type: MPU Moduler

Specifications of 101-1050

• Contents: RabbitCore Module, Dev. Board, AC Adapter, Cable and Dynamic C® CD-Rom
• Processor To Be Evaluated: RCM3750
• Data Bus Width: 8 bit
• Interface Type: Ethernet
• For Use With/related Products: RCM3750
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 101-1049; 101-1049; 316-1117; Q2479714; Q2828455

2.2.2 Connect Programming Cable
The programming cable connects the RCM3750 to the PC running Dynamic C to down-
load programs and to monitor the RCM3750 module during debugging.
Connect the 10-pin connector of the programming cable labeled
the RCM3750 as shown in Figure 3. Be sure to orient the marked (usually red) edge of the
cable towards pin 1 of the connector. (Do not use the
normal serial connection.)
Connect the other end of the programming cable to a COM port on your PC.
User’s Manual
NOTE: Be sure to use the programming cable (part number 101-0542) supplied with this
NOTE: Some PCs now come equipped only with a USB port. It may be possible to use
Development Kit—the programming cable has blue shrink wrap around the RS-232 con-
verter section located in the middle of the cable. The simplified programming cable and
adapter board that are supplied with the Ethernet Connection Kit may also be used as
shown in the inset diagram above. Programming cables from other Rabbit Semiconduc-
tor kits are not designed to work with RCM3750 modules.
an RS-232/USB converter (Part No. 540-0070) with the programming cable supplied
with the RCM3750 Development Kit. Note that not all RS-232/USB converters work
with Dynamic C.
Figure 3. Connect Programming Cable and Power Supply
DIAG
connector, which is used for a
PROG
to header J2 on
9