DK-CYCII-2C20N Altera, DK-CYCII-2C20N Datasheet - Page 16

• Manufacturer Part Number: DK-CYCII-2C20N
• Description: CYCLONE II STARTER KIT EP2C20N
• Manufacturer: Altera
• Series: Cyclone® IIr
• Type: FPGAr

Specifications of DK-CYCII-2C20N

• Contents: Dev Board, Quartus®II Web Edition, Nios®II Web Edition, Cables, Accessories, Reference Designs and Demos
• Silicon Manufacturer: Altera
• Core Architecture: FPGA
• Core Sub-architecture: Cyclone
• Silicon Core Number: EP2C
• Silicon Family Name: Cyclone II
• Rohs Compliant: Yes
• For Use With/related Products: Cyclone®II FPGAs
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 544-1736

Powering Up the Development Board
Powering Up the
Development
Board
Confirming
Board Operation
2–2
Cyclone II FPGA Starter Development Kit User Guide
■
■
1
To power up the development board, perform the following steps:
1.
2.
3.
4.
5.
6.
As the development board powers on, verify correct operation by
performing the following steps:
1.
2.
3.
Install the Altera Quartus
already installed
The Cyclone II FPGA Starter Development Board includes an
integrated USB-Blaster™ chip set for programming the FPGA. Install
the Altera USB-Blaster driver software on the host computer, if not
already installed.
Connect the USB-Blaster cable from the host computer to the
USB-Blaster port on the development board.
Connect the 7.5 V DC adapter to the development board and to a
power source.
Connect a VGA monitor to the VGA video port on the development
board.
Connect a headset to the Line Out audio port on the development
board.
Slide the RUN/PROG switch on the edge of the development board
to the RUN position.
Turn the power on by depressing the ON/OFF switch on the
development board.
Confirm that all user LEDs are flashing.
Confirm that all 7-segment displays cycle through numbers 0
through F.
Confirm that the VGA monitor displays the default image
(Figure
edge of the board) position.
Communication between the computer host and the
development board requires Altera USB-Blaster driver software
already installed on the host computer.
2–2) with the SW0 switch set to the DOWN (toward the
®
software on the host computer, if not
Altera Corporation
October 2006