SI85XX-EVB Silicon Laboratories Inc, SI85XX-EVB Datasheet - Page 15

• Manufacturer Part Number: SI85XX-EVB
• Description: BOARD EVAL CURRENT SENSOR 10A
• Manufacturer: Silicon Laboratories Inc

Specifications of SI85XX-EVB

• Sensor Type: Current Sensor
• Sensing Range: 10A
• Interface: Analog
• Voltage - Supply: 2.7 V ~ 5.5 V
• Embedded: No
• Utilized Ic / Part: Si8512
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Sensitivity: -
• Lead Free Status / Rohs Status: Supplier Unconfirmed
• Other names: 336-1425

3.3.2. Selecting Reset Timing Signals
Reset timing signals should be chosen to meet the
following conditions:



3.3.3. Configuring Integrator Reset
Per Section “2. Functional Overview”, the integrator
must be reset (zeroed) prior to the start of each
measurement cycle to achieve specified measurement
accuracy. This reset must be synchronized with the
system switch timing signals to ensure that current is
measured during the appropriate time; so, the Si85xx
integrator reset circuitry uses system timing as its
reference. Timing signals connect to reset inputs R1
through R4 where built-in logic functions allow the user
to choose the conditions that cause an integrator reset
event. Important Note: reset inputs R1–R4 are rated to
a maximum input voltage of VDD. External resistor
dividers must be used when connecting driver output
signals to R1–R4 that swing beyond VDD.
As shown in Table 11, the Si850x integrator reset logic
is a simple XOR gate where reset is maintained (or
triggered, depending on use of the TRST input) when
states of reset inputs R1 and R2 are not equal.
Figure 13 shows the logic for the Si851x products,
where any one of three reset logic functions can cause
integrator
determined by the states of the Mode and R4 inputs, as
shown in Table 11.
Satisfy reset time t
Not overlap integrator reset into the desired
measurement period
Not violate reset watchdog timeout period t
reset.
The
R
output
mode
(Si851x)
WD
Preliminary Rev. 0.21
is
Si85xx
15