CYIL1SM4000-EVAL Cypress Semiconductor Corp, CYIL1SM4000-EVAL Datasheet - Page 11

• Manufacturer Part Number: CYIL1SM4000-EVAL
• Description: BOARD EVAL IMAGE SENS LUPA-4000
• Manufacturer: Cypress Semiconductor Corp

Specifications of CYIL1SM4000-EVAL

• Sensor Type: CMOS Imaging, Monochrome
• Sensing Range: 4 Megapixel
• Interface: SPI
• Sensitivity: 15 fps
• Voltage - Supply: 2.5 V ~ 3.3 V
• Embedded: No
• Utilized Ic / Part: LUPA-4000
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Contains lead / RoHS non-compliant

3 Sensor architecture
A schematic drawing of the architecture is given in the block diagram below. The
image core consists of a pixel array, one X- and two Y-addressing registers (only one
drawn), pixel array drivers and column amplifiers. The image sensor of 2048 * 2048
pixels is read out in progressive scan. One or two output amplifiers read out the
image sensor. The output amplifiers are working at 66MHz pixel rate nominal speed
or each at 33MHz pixel rate in case the 2 output amplifiers are used to read out the
imager. The complete image sensor has been designed for operation up to 66MHz.
The structure allows having a programmable addressing in the x-direction in steps of
2 and in the y-direction in steps of 2 (only even start addresses in X- and Y-direction
are possible). The starting point of the address is uploadable by means of the Serial-
Parallel Interface (SPI).
Contact:
Cypress Semiconductor Corporation
LUPA-4000
Data Sheet
Clk_y sync_y
eos_y
[e-mail]
sync_x
Clk_x
Figure 3: Block diagram of the image sensor
Logic blocks
Document #: 38-05712 Rev.**(Revision 1.2 )
3901 North First Street
Column amplifiers
On chip drivers
X shift register
2048 * 2048
pixel array
SPI
San Jose, CA 95134
DAC
Page 11 of 49
eos_x
Reset, mem_hl,
precharge, samp
2 differentia
outputs
408-943-2600