E1106 Atmel, E1106 Datasheet - Page 4

• Manufacturer Part Number: E1106
• Description: BOARD EVALUATION FOR QT1106-ISG
• Manufacturer: Atmel

Specifications of E1106

• Sensor Type: *
• Sensing Range: *
• Interface: *
• Sensitivity: *
• Voltage - Supply: *
• Embedded: *
• Utilized Ic / Part: *
• Interface Type: USB
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: QT1106
• Other names: E1106AT

2
USB cable to computer
Setting Up the E1106
To prepare the E1106 for use, proceed as follows:
1. Connect the E1106 control board to the QWheel or QSlide evaluation assembly, ensuring
2. Using the USB cable provided, connect the E1106 control board to the computer (see
3. Install the QT1106 Demo software; either method is acceptable:
4. QT1106 Demo software is displayed on the computer monitor (see Figure 3, page 5).
Note: the E1106 QWheel and QSlide assemblies are supplied with a grounded transparent
backplate that allows the assemblies to be operated while being handheld, without requiring
recalibration. The backplate can be removed if required.
Figure 2: E1106 Connections
correct orientation of the connector (see Figure 2).
Figure 2). The LED on the E1106 is lit constantly to indicate that there is power to the board.
a. Put the supplied CD in the CD drive of the computer. Copy the contents of the CD to the
OR
b. Go to www.qprox.com, point to the Support tab and click Download Archive. Click
computer. Double-click the QT1106 Demo software to open it.
If a dialog box appears saying “The publisher could not be verified. Are you sure you want
to run this software?” click Run.
Software and then the QT1106 Demo link. A dialog box appears asking if you want to run
or save the file that you are about to download. Click Run. This automatically downloads
the software.
Connecting the E1106 Control Board to the E1106 QWheel or QSlide
LED
Connections between the E1106 Control Board and computer
E1106 User Manual
4 of 14
Control board
component
should be
side up.
QWheel
Assembly