ATQT600 Atmel, ATQT600 Datasheet - Page 124

• Manufacturer Part Number: ATQT600
• Description: KIT EVAL TOUCH FOR QT600
• Manufacturer: Atmel
• Series: QTouch™r

Specifications of ATQT600

• Sensor Type: Touch Screen
• Interface: USB
• Embedded: Yes, Other
• Utilized Ic / Part: ATtiny88, ATmega324PA, ATxmega128A1
• Processor To Be Evaluated: ATtiny88, ATmega324, ATxmega128
• Data Bus Width: 8 bit, 16 bit
• Interface Type: USB
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Operating Supply Voltage: 1.6 V to 3.6 V
• Silicon Manufacturer: Atmel
• Kit Application Type: Sensor
• Application Sub Type: Touch Sensor
• Kit Contents: USB Bridge, MCU Cards, Touchpad Cards
• Svhc: No SVHC (15-Dec-2010)
• Mcu Supported Families: ATtiny88,
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Voltage - Supply: -
• Sensitivity: -
• Sensing Range: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

QTouch Sensor if required
Re-enable Autonomous
6.3.9.4
For the Autonomous QTouch operation, the CAT_CLK must be setup appropriately as a first step.
The Autonomous QTouch and Common configuration parameters in the touch_config_at32uc3l.h
configuration must then be set up.
The touch_at_sensors_init API initializes the QTouch Library as well as the CAT module for the
Autonomous QTouch sensor related pin, register and Global Sensor configuration.
Autonomous QTouch Sensor can be enabled at any time by the Host Application. Once the
Autonomous QTouch Sensor is enabled, the CAT module performs measurements on this sensor
continuously to detect a Touch Status. When an IN_TOUCH or OUT_OF_TOUCH status is
detected, the QTouch Library calls the touch_at_status_change_interrupt_callback function to
indicate the status to the Host application. It is possible to enable and disable Autonomous
QTouch sensor multiple times in the Host application by using the touch_at_sensor_enable and
touch_at_sensor_disable API.
6.3.9.5
The touch_at_sensor_enable and touch_at_sensor_disable API can be used for Enabling and
Disabling and the Autonomous QTouch Sensor.
enabled, the CAT module performs continuous Touch Measurements on the Sensor in order to
detect the Touch Status.
124
Autonomous QTouch Sensor API Flow for UC3L
Autonomous QTouch method Enable and Disable Sensor for UC3L
Using the init_clock() in main.c and clock.c files,
Set the CAT_CLK Clock to appropriate value.
Using the touch_config_at32uc3l.h configuration file,
Set DEF_TOUCH_AUTONOMOUS_QTOUCH = 1.
Set all AT_xx and TOUCH_xx macros to appropriate values.
Figure 44 Autonomous QTouch API Flow diagram
touch_at_sensor_disable()
touch_at_sensor_enable()
touch_at_sensor_init()
QTouch Sensor if required
Disable Autonomous
6.3.9.4.1
Once the Autonomous QTouch sensor is
touch_at_status_change_interrupt_callback(),
The callback is called as long
Autonomous QTouch Status
as Autonomous QTouch
sensor is not disabled
8207J-AT42-02/11
The