DS3150DK Maxim Integrated Products, DS3150DK Datasheet - Page 3

• Manufacturer Part Number: DS3150DK
• Description: KIT DEMO DS3150 DS3/E3/STS-2 LIU
• Manufacturer: Maxim Integrated Products

Specifications of DS3150DK

• Main Purpose: Telecom
• Utilized Ic / Part: DS3150
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Secondary Attributes: -
• Embedded: -
• Primary Attributes: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

JUMPERS
Configuration Inputs. The jumpers on the DS3150DK allow the user to configure the DS3150 in any of
its operating modes (Figure 2). Each configuration input pin on the DS3150 has a corresponding jumper
to connect the pin to V
the DS3150 configuration pins are wired to the center posts of the jumper sites. Additional board
markings indicate that a V
connected to the bottom posts. Jumpers JP3, JP5, JP7, JP8, JP9, JP10, JP11, JP12, JP13, and JP14 control
configuration input pins on the DS3150.
TCLK. On the right side of the board, jumper JP1 connects either the T3 oscillator output or the E3
oscillator output to the intermediate node OSC. Install JP1 between top and middle posts for an E3 clock
or between the middle and bottom posts for a T3 clock. Install jumper JP2 to connect the DS3150 TCLK
pin to the OSC node. Leave JP2 uninstalled to source TCLK from the System Connector.
MCLK. Jumpers JP4 and JP6 control the DS3150 MCLK pin. Install jumper JP4 (and not JP6) to
connect the DS3150 MCLK pin to the OSC node. Install jumper JP6 (and not JP4) to connect the MCLK
pin to V
Figure 2. DS3150DK JUMPERS
CC
or GND. Leave both JP4 and JP6 uninstalled to source MCLK from the System Connector.
DD
OSC
or GND (or leave it floating). Silk-screen labels around the jumpers show that
CC
rail is connected to the top post of each jumper site while a GND rail is
JP4
OSC
GND
VDD
GND
VDD
E3
T3
JP2
JP1
JP6
3 of 12
EFE, ICE,
LBKS*, LBO,
RMON, TDS0,
TDS1/OFSEL,
TESS, TTS*
and ZCSE*
MCLK
TCLK
OSC
SYSTEM CONNECTOR
SYSTEM CONNECTOR