EVB-2502 SMSC, EVB-2502 Datasheet - Page 19

• Manufacturer Part Number: EVB-2502
• Description: BOARD EVALUATION FOR USB2502
• Manufacturer: SMSC

Specifications of EVB-2502

• Main Purpose: Interface, USB 2.0 Hub
• Embedded: No
• Utilized Ic / Part: USB2502
• Primary Attributes: Dual Port Hub, High Speed (480Mbps)
• Secondary Attributes: Overcurrent Protection, Port Power Switching
• Interface Type: USB
• Operating Supply Voltage: 5 V
• Product: Interface Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: USB2502
• Other names: 638-1037

2-Port USB 2.0 Hub Controller
Datasheet
SMSC USB2502
5.2
5.2.1
5.2.1.1
5.2.1.2
5.2.1.3
5.2.2
5.2.3
VID
PID
DID
FIELD
EEPROM Interface
The SMSC Hub can be configured via a 2-wire (I2C) EEPROM. (Please see
Pin Descriptions"
The Internal state-machine will, (when configured for EEPROM support) read the external EEPROM
for configuration data. The hub will then “attach” to the upstream USB host.
Please see
I2C EEPROM
The I2C EEPROM interface implements a subset of the I2C Master Specification (Please refer to the
Philips Semiconductor Standard I2C-Bus Specification for details on I2C bus protocols). The Hub’s I2C
EEPROM interface is designed to attach to a single “dedicated” I2C EEPROM, and it conforms to the
Standard-mode I2C Specification (100kbit/s transfer rate and 7-bit addressing) for protocol and
electrical compatibility.
Note: Extensions to the I2C Specification are not supported.
The Hub acts as the master and generates the serial clock SCL, controls the bus access (determines
which device acts as the transmitter and which device acts as the receiver), and generates the START
and STOP conditions.
Implementation Characteristics
Please refer to the MicroChip 24AA00 DataSheet for Protocol and Programming specifics.
Pull-Up Resistor
The Circuit board designer is required to place external pull-up resistors (10K Ω recommended) on the
SDA/SMBDATA & SCL/SMBCLK/CFG_SELO lines (per SMBus 1.0 Specification, and EEPROM
manufacturer guidelines) to Vcc in order to assure proper operation.
I2C EEPROM Slave Address
Slave address is 1010000.
Note: 10-bit addressing is NOT supported.
In-Circuit EEPROM Programming
The EEPROM can be programmed via ATE by pulling RESET_N low (which tri-states the Hub’s
EEPROM interface and allows an external source to program the EEPROM).
EEPROM DATA
BYTE
MSB:
LSB
1:0
3:2
5:4
Table 5.1
(BYTES)
SIZE
for specific details on how to enable the I2C EEPROM option).
2
2
2
User-Defined Descriptor Data for a list of data fields available.
Table 5.1 User-Defined Descriptor Data
0424
2502
0000
DEFAULT
(HEX)
SELF
CFG
DATASHEET
0424
2502
0000
DEFAULT
19
(HEX)
CFG
BUS
Vendor ID (assigned by USB-IF).
Product ID (assigned by Manufacturer).
Device ID (assigned by Manufacturer).
DESCRIPTION
Table 4.1, "7-Port Hub
Revision 2.3 (08-27-07)