IS-DEV KIT-8 NKK Switches, IS-DEV KIT-8 Datasheet - Page 15

• Manufacturer Part Number: IS-DEV KIT-8
• Description: SMARTSWITCH DEVELOPMENT KIT 8
• Manufacturer: NKK Switches
• Series: SmartSwitch™r

Specifications of IS-DEV KIT-8

• Main Purpose: Switches with Programmable Display
• Utilized Ic / Part: SmartSwitch™OLED Rocker Switch
• Primary Attributes: OLED Rocker Switch
• Description/function: SMARTSWITCH Development Kit
• Maximum Operating Temperature: + 70 C
• Operating Voltage: 2.7 V to 5.5 V
• For Use With: 360-2431 - SERIAL CBL RJ11-DB9 FOR DEV KIT360-2430 - POWER SUPPLY 240VAC FOR DEV KIT360-2429 - POWER SUPPLY 120VAC FOR DEV KIT
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Secondary Attributes: -
• Embedded: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: OLED Smartswitch Rocker
• Other names: 360-2421

7850 East Gelding Drive • Scottsdale, AZ 85260-3420
Commands are one byte in the range of 20H to 2FH and 01H and are transmitted in hex format. The proper
format for all command options and data is specified for each command. See Section 7.
Communication initiated by the IS-Dev Kit-8
The Dev Kit transmits codes to host via RS232 based on activities stated below. Many of these reporting can
be enable/disabled by the flag setup.
7.
Command to reboot the controller
The command reboots the controller to power-up state.
The controller resets itself and transmits 11H when it is ready for operation. Please note there may be other
bytes transmitted before 11H, depending on the state of the controller at the reset time.
Command to check communication
The command is used to check if the controller is on-line.
The controller transmits back 61H to the host. This command does not effect the controller operation.
IS-Dev Kit 8 Users Manual A.doc
A. A timer is set. If the expected data byte is not received in 64ms, the controller transmits 6CH 6EH and
B. If the byte value is not acceptable (invalid range, option, etc.), the controller transmits 6EH and
A. Top switch press is reported as 91H
B. Top switch Release is reported as C1H
C. Middle switch press is reported as 92H
D. Middle switch Release is reported as C2H
E. Bottom switch press is reported as 93H
F. Bottom switch Release is reported as C3H
G. Timer Expire is reported as 94H
H. Upon changing the image, the image address is reported as FCH followed by the address in HEX so
I. If there is a communication problem between microcontroller and the microSD flash, the controller
terminates the routine.
terminates the routine.
total of 3 bytes transmitted for each image change.
will transmit 6FH to host for each communication failure.
command format:
transmit format:
command format:
transmit format:
Commands
Toll Free 1.877.2BUYNKK (877.228.9655) • Phone [phone] • Fax [phone]
(xxH)
(xxH)
24H
01H
www.nkkswitches.com • Email [e-mail]
IS-Dev Kit-8 User Manual
Page 15 of 31
1209