MCP2515DM-PCTL Microchip Technology, MCP2515DM-PCTL Datasheet - Page 54
![BOARD DEMO FOR MCP2515](/photos/9/4/90422/microchip_technology-_mcp2515dm-pctl_sml.jpg)
MCP2515DM-PCTL
Manufacturer Part Number
MCP2515DM-PCTL
Description
BOARD DEMO FOR MCP2515
Manufacturer
Microchip Technology
Series
PICtail™r
Type
Network Controller & Processorr
Specifications of MCP2515DM-PCTL
Main Purpose
Interface, CAN Controller
Embedded
Yes, MCU, 8-Bit
Utilized Ic / Part
MCP2515, MCP25020
Primary Attributes
Stand alone CAN Controller with CAN I/O Expander
Interface Type
CAN
Operating Voltage
5 V
Product
Modules
For Use With/related Products
MCP2515, MCP25020
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Secondary Attributes
-
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
MCP2515
FIGURE 8-3:
TABLE 8-1:
DS21801F-page 54
Capacitor values are for design guidance only:
These capacitors were tested with the resonators
listed below for basic start-up and operation. These
values are not optimized.
Different capacitor values may be required to
produce acceptable oscillator operation. The user
should test the performance of the oscillator over the
expected V
application.
See the notes following
information.
Mode
HS
Typical Capacitor Values Used:
DD
16.0 MHz
8.0 MHz
and temperature range for the
Freq.
Resonators Used:
CAPACITOR SELECTION FOR
CERAMIC RESONATORS
74AS04
330 kΩ
16.0 MHz
EXTERNAL SERIES RESONANT CRYSTAL OSCILLATOR CIRCUIT
4.0 MHz
8.0 MHz
Note 1: Duty cycle restrictions must be observed (see
Table 8-2
OSC1
27 pF
22 pF
for additional
0.1 mF
XTAL
OSC2
27 pF
22 pF
74AS04
330 kΩ
TABLE 8-2:
Capacitor values are for design guidance only:
These capacitors were tested with the crystals listed
below for basic start-up and operation. These values
are not optimized.
Different capacitor values may be required to
produce acceptable oscillator operation. The user
should test the performance of the oscillator over the
expected V
application.
See the notes following this Table for additional
information.
Note 1:
Type
74AS04
Osc
HS
2:
3:
4:
(1)(4)
While higher capacitance increases the
stability of the oscillator, it also increases
the start-up time.
Since each resonator/crystal has its own
characteristics, the user should consult
the resonator/crystal manufacturer for
appropriate values of external
components.
R
crystals with low drive level specification.
Always verify oscillator performance over
the V
expected for the application.
DD
S
To Other
Devices
may be required to avoid overdriving
and temperature range for the
Table
DD
20 MHz
Crystal
Freq.
4 MHz
8 MHz
CAPACITOR SELECTION FOR
CRYSTAL OSCILLATOR
Crystals Used
and temperature range that is
20.0 MHz
(2)
12-1).
4.0 MHz
8.0 MHz
© 2010 Microchip Technology Inc.
MCP2510
OSC1
Typical Capacitor
27 pF
22 pF
15 pF
(3)
C1
Values Tested:
(1)
:
27 pF
22 pF
15 pF
C2