AC164120 Microchip Technology, AC164120 Datasheet - Page 33

• Manufacturer Part Number: AC164120
• Description: BOARD SIGNAL ANALYSIS PICKIT
• Manufacturer: Microchip Technology
• Series: PICtail™r

Specifications of AC164120

• Main Purpose: Interface, Signal Analysis
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: PICkit™ PICtail™1
• Primary Attributes: Real-time Strip Chart, Oscilloscope, Fast Fourier Transformation (FFT)
• Secondary Attributes: Histogram
• Silicon Manufacturer: Microchip
• Core Architecture: PIC
• Core Sub-architecture: PIC16
• Features: Real-Time Strip Chart, Fast Fourier Transformation
• Silicon Core Number: PIC16F
• Silicon Family Name: PIC16F6xxx
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: PICkit Flash Starter Kit
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

MPLAB
a PICmicro
executed in real time or single step, watch variables
established, break points set, memory read/writes
accomplished and more. It can also be used as a
development programmer for the microcontrollers.
The MPLAB ICD 2 allows debugging of selected Flash-
based Microchip microcontrollers using MPLAB
Integrated Development Environment (IDE). This
powerful graphical user interface is included with each
unit as a free tool. It is the ideal tool for embedded
control designers who do not have the budget for a
high-cost, in-circuit emulator.
 2004 Microchip Technology Inc.
Ordering Information:
DV164005
DV164006
DV164007
DV164030
DV164032
DS51264
®
target microcontroller. Programs can be
®
MPLAB
MPLAB
(Includes MPLAB ICD 2 Module, USB Cable, RS-232 Cable, Power Supply and
PICDEM™ 2 Plus Demonstration Board - DM163022)
MPLAB
(Includes MPLAB ICD 2 Module, USB Cable, RS-232 Cable and Power Supply)
MPLAB
MPLAB
MPLAB
ICD 2 In-Circuit Debugger
®
®
®
®
®
®
ICD 2 Module (Includes MPLAB ICD 2 Module and USB Cable)
ICD 2 Evaluation Kit
ICD 2 Module ws
ICD 2 with dsPICDEM Starter Demo Board
ICD 2 with dsPICDEM 1.1 General Purpose Demo Board
ICD 2 Sell Sheet (Available at: www.microchip.com)
The MPLAB
ICD 2 module
is a low-cost
development
tool that
connects
between the
PC and the
designers target
board allowing
direct in-circuit
debugging of
Shared overhead is: one stack level, some general
purpose file registers and a small bank of program
memory when in the debug mode and two hardware
pins (RB6 and RB7) lines.
The MPLAB ICD 2 is firmware-based, which allows it to
be enhanced to support future microcontroller products
and new features extending the tool life and making it a
valued buy. Firmware downloads are available from the
Microchip web site at: www.microchip.com.
Features
• USB (full speed 2 Mbits/s) and RS-232 interface
• Real time background debugging
• Built-in over voltage/short circuit monitor
• Supports low-voltage operation to 2.0 volts
• Diagnostic LED’s (power, busy, error)
• Reading/writing memory space and stack of
• Erase of program memory space with verification
• Freeze on halt
• Programs many Flash devices
to host PC
target microcontroller
Low Cost Debugger
DS30177S-page 31