VDIP2 FTDI, Future Technology Devices International Ltd, VDIP2 Datasheet - Page 11

• Manufacturer Part Number: VDIP2
• Description: MOD MCU-USB HOST CTLR 40-DIP
• Manufacturer: FTDI, Future Technology Devices International Ltd
• Series: Vinculumr

Specifications of VDIP2

• Main Purpose: Interface, USB 2.0 Host/Controller
• Embedded: Yes, ASIC
• Utilized Ic / Part: VNC1L-1A
• Primary Attributes: Dual A-Type Connector, UART / Parallel FIFO / SPI Interfaces
• Secondary Attributes: Firmware Update via USB Flash Drive or UART, Traffic LEDs
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 768-1002

3.6 Signal Descriptions – Serial Peripheral Interface (SPI)
The SPI I/O pin description of the VNC1L device are shown in
Pins No
Table 3.5 - Data and Control Bus Signal Mode Options – SPI Slave Interface
When in SPI mode, the timing of a read operation is shown in Figure 3.3
From Start - SPI CS must be held high for the entire read cycle, and must be taken low for at least one
clock period after t he read is co mpleted. The first bit on SPI Data In is the R/W bit - inputting a ‘1’ here
a llows data to be read fro m the chip. The next bit is the address bit, ADD, which is used to indicate
whether the data register (‘0’) or the status register (‘1’) is read from. During the SPI read cycle a byte of
data will start being output on SPI Data Out on the next clock cycle after t he address bit, MSBAfterfirst.t
he data has been clocked out of the chip, t he status of SPI Data. Out should be checked to see if the
data read is new data. A ‘0’ level here on SPI Data Out means that the data read is new data. A ‘1’
indicates that the data read is old data, and the read cycle should be repeated to get new data.
Remember that CS must be held low for at least one clock period before being taken high again to
continue with the next read or write cycle.
14
16
17
18
Figure 3.3 – SPI Slave Data Read Cycle.
3.6.1 SPI Slave Data Read Cycle
Copyright © 2009 Future Technology Devices International Limited
`
SCLK
SDI
SDO
CS
Name
Input
Input
Output
Input
VDIP2 Vinculum VNC1L Module Datasheet Version 1.0
Type
Table 3.5
SPI Clock input, 12MHz maximum.
SPI Serial Data Input
SPI Serial Data Output
SPI Chip Select Input
Document Reference No.: FT_000017
Description
Clearance No.: FTDI# 145
10