AS5046 PB austriamicrosystems, AS5046 PB Datasheet - Page 24

• Manufacturer Part Number: AS5046 PB
• Description: BOARD PROGRAM AS5046
• Manufacturer: austriamicrosystems

Specifications of AS5046 PB

• Module/board Type: Socket Adapter
• For Use With/related Products: AS5000 Programmer, AS5046
• Lead Free Status / RoHS Status: Lead free by exemption / RoHS compliant by exemption

AS5046
Data Sheet
Figure 11
Note:
1)
2)
14.1.2 Diagnostic Output Mode
Figure 12
In Diagnostic Output Mode (see Figure 12) the analog output of the internal DAC ranges from 10% - 90% Vref
error case, either when the supply is interrupted or when the magnetic field is in the “red” range, (see Table 20) the
output is switched to 0V and thus indicates the error condition.
It is possible to enable the analog output permanently (it will not be switched off even if the magnetic field is out of
range). To enable this feature an OTP bit in the factory setting must be set. The corresponding bit is FS6. See
Application Note AS5040-20 (Extended features of OTP programming) for further details. The application note is
available for download at the austriamicrosystems website.
The analog and digital outputs will have the following conditions:
Table 22 Conditions for Analog and Digital Outputs
www.austriamicrosystems.com
Normal operation
Magnetic field out of range
Status
For simplification, Figure 11 describes a linear output voltage from rail to rail (0V to VDD). In practice, this is not
feasible due to saturation effects of the OPAMP output driver transistors. The actual curve will be rounded
towards the supply rails (as indicated in Figure 11).
Figure 11 and are shown for 360° operation. See Table 23 (page 29) for further angular range programming
options.
Analog Output, Full Scale Mode (shown for 360°mode)
Diagnostic Output Mode
analog
output
voltage
100%
analog
output
voltage
Vref
0V
100%
10%
0%
90%
Vref
0°
0°
90°
90°
10% - 90% Vref
< 10% Vref
output is switched to 0V
(this feature may be
disabled in OTP; see
text)
DAC Output Voltage
Revision 1.12
180°
180°
1)
, DAC
1)
In an error case, the output
voltage is in the grey area
270°
270°
#0 - #1023 (0°-360°), MagRngn = 1
#0 - #1023 (0°-360°)
out of range is signaled in status bits:
MagInc=MagDec=LIN=1, MagRngn= 0
Serial Digital Output
360°
360°
normal
operating
area
angle
angle
24 – 42
*)
. In an