LFM34INTPU1A Freescale Semiconductor, LFM34INTPU1A Datasheet - Page 52

• Manufacturer Part Number: LFM34INTPU1A
• Description: ADAPTER MPC5534 324-BGA
• Manufacturer: Freescale Semiconductor

Specifications of LFM34INTPU1A

• Module/board Type: Adapter Board
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: -

Revision History for the MPC5534 Data Sheet
5
The history of revisions made to this data sheet are described in this section. The changes are divided into
each revision of this document.
The substantive changes incorporated in MPC5534 Data Sheet revision 4.0 to produce revision 5.0 are:
Within each group, the changes are listed in sequential page number order.
5.1
The following table lists the substantive text changes made to paragraphs.
5.2
The following table lists the substantive text changes made to paragraphs.
52
Title page:
Section 3.2.1, “General Notes for Specifications at Maximum Junction Temperature
Table 16 on page 24
4 Mechanicals:
Section 3.7, “Power-Up/Down Sequencing
Location
•
•
Text changes
Table and figure changes
Changes Between Revisions 4.0 and 5.0
Changes Between Revisions 3.0 and 4.0
Changed the Revision number from 4.0 to 5.0. Changed the date format to DD MMM YYYY. Made the same
changes in the lower left corner of the back page.
Updated the address of Semiconductor Equipment and Materials International
3081 Zanker Rd.
San Jose, CA., 95134
[phone]
Added footnote 9: For frequencies up to and including 80 MHz, if VDD is within ±5% of 1.5 V, then
APC = RWSC = 0b010 is a valid setting.
Added the following NOTE before the 208 and 324 BGA Maps:
Last paragraph: Changed the first sentence FROM . . . the voltage on the pins goes to high-impedance until . . .
TO. . .the pins go to a high-impedance state until . . .
Revision History for the MPC5534 Data Sheet
The MPC5500 devices are pin compatible for software portability and use the primary
function names to label the pins in the BGA diagram. Although some devices do not support
all the primary functions shown in the BGA diagram, the muxed and GPIO signals on those
pins remain available. See the signals chapter in the device reference manual for the signal
muxing.
Table 28. Text Changes Between Rev. 4.0 and 5.0
MPC5534 Microcontroller Data Sheet, Rev. 5
Description of Changes
NOTE
Freescale Semiconductor