AE-ISP-U2 Phyton Inc, AE-ISP-U2 Datasheet - Page 3

• Manufacturer Part Number: AE-ISP-U2
• Description: ADAPTER UNIV ISP DIP28/BH10
• Manufacturer: Phyton Inc

Specifications of AE-ISP-U2

• Accessory Type: Adapter Board
• For Use With/related Products: ChipProg-40, ChipProg-48, ChipProg-G4
• For Use With: CHIPPROG-G4 - PROGRAMMER GANG 4 SOCKETCHIPPROG-40 - PROGRAMMER STANDALONE 40-DIPCHIPPROG-48 - PROGRAMMER STANDALONE 48-DIP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

AE-ISP-U2
AE-ISP-U2 connection for LPC Flash and Firmware Hub
Click the programmer model below to get an appropriate list of the devices supported by the adapter:
Recommended connection:
Table of connections of the adapter output socket to the device pins:
http://www.phyton.com/downloads/adp/HTML/ae-isp-u2.html
Adapter Output connector, BH-10 Target Device LPC Flash or Firmware Hub
ChipProg-40
ChipProg-48, ChipProg-G4
6,7,8
7,8,9
10
10
9
1
2
3
4
5
6
GND
TDI
-
There are two alternative options for powering the targets:
1. The target gets power from the programmer (Vdd). This is
possible only if the target does not consume too much energy. A
capacity of the target power circuitry should not exceed 50 uF.
2. The target gets power from a built-in or external power
supply. In this case the power output from the programmer
should not be connected with the target. The target system
should be tolerant to applying logical signals with the voltage
levels exceeding the voltages on the target.
NOTE! It is strictly prohibited to power the target from both the
programmer and built-in or external power supply
simultaneously.
Purpose of the R1..R5 resistors is to isolate the programmed chip
from rest of target system. Recommended value of resistors
R1..R5 is 2k or more. You can also use jumpers instead of the
resistors.
LFRAME
LCLK
LAD0
LAD1
LAD2
LAD3
GND
VCC
Page 3 of 3
12/3/2009