HS7011ECN61H Renesas Electronics America, HS7011ECN61H Datasheet - Page 19

• Manufacturer Part Number: HS7011ECN61H
• Description: DEV EMULATOR PCB ADAPTOR
• Manufacturer: Renesas Electronics America

Specifications of HS7011ECN61H

• Accessory Type: User Interface Cable
• For Use With/related Products: SH7011
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

2.2.4
Fasten the user system interface cable head to the IC socket for an TFP-100B package on the user
system with the four screws (M2.6
be tightened a little at a time, alternating between screws on opposing corners. Take special care,
such as manually securing the IC socket soldered area, to prevent the soldered IC socket from
being damaged by overtightening the screws or twisting the components.
6
1. Use a Phillips-type screwdriver whose head matches
2. The tightening torque must be 0.294 N•m or less.
3. If the emulator does not operate correctly, cracks might
Fastening Cable Head
the screw head.
If the applied torque cannot be accurately measured,
stop tightening when the force required to turn the screw
becomes significantly greater than that needed when first
tightening. If a screw is tightened too much, the screw
head may break or an IC socket contact error may be
caused by a crack in the IC socket solder.
have occurred in the solder. Check conduction with
a tester and re-solder the IC socket if necessary.
x
CAUTION
12 mm; with four flat washers) provided. Each screw should