HS7047ECH61H Renesas Electronics America, HS7047ECH61H Datasheet - Page 15

• Manufacturer Part Number: HS7047ECH61H
• Description: DEV EMULATOR PCB ADAPTOR FP-100M
• Manufacturer: Renesas Electronics America

Specifications of HS7047ECH61H

• Accessory Type: User Interface Cable
• For Use With/related Products: SH7047
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

2.1.2
Align pin 1 on the IC socket for an FP-100M package on the user system with pin 1 on the user
system interface board, and insert the user system interface board into the IC socket on the user
system, as shown in figure 2.
2.1.3
Fasten the user system interface board to the IC socket for an FP-100M package on the user system
with the four screws (M2.6
alternating between screws on opposing corners. Take special care, such as manually securing the
IC socket soldered area, to prevent the soldered IC socket from being damaged by overtightening
the screws or twisting the components.
4
1. Use a Phillip-type screwdriver whose head matches the
2. The tightening torque must be 0.294 N•m or less.
3. If the emulator does not operate correctly, cracks might
screw head.
Installing Cable Head
Check the location of pin 1 before inserting.
Fastening Cable Head
If the applied torque cannot be accurately measured,
stop tightening when the force required to turn the screw
becomes significantly greater than that needed when first
tightening. If a screw is tightened too much, the screw
head may break or an IC socket contact error may be
caused by a crack in the IC socket solder.
have occurred in the solder. Check conduction with
a tester and re-solder the IC socket if necessary.
x
12 mm) provided. Each screw should be tightened a little at a time,
CAUTION
CAUTION