HSB-15-1.5 TDK Corporation, HSB-15-1.5 Datasheet - Page 2

• Manufacturer Part Number: HSB-15-1.5
• Description: PWR SUP 15V 22.5W 1.5A SNG OUT
• Manufacturer: TDK Corporation
• Series: Hr

Specifications of HSB-15-1.5

• Voltage - Output: 15V
• Number Of Outputs: 1
• Power (watts): 22W
• Applications: Commercial
• Power Supply Type: Linear, Regulated (Open Frame)
• Voltage - Input: 100, 120, 220, 230, 240VAC
• Mounting Type: Chassis Mount
• 1st Output: 15 VDC @ 1.5A
• Size / Dimension: 3.98" L x 4.88" W x 1.61" H (101mm x 124mm x 41mm)
• Power (watts) - Rated: 22.5W
• Operating Temperature: 0°C ~ 70°C
• Efficiency: 55%
• Approvals: CE, EN, UL
• Line Regulation: ±0.05%
• Load Regulation: ±0.05%
• Power Supply Output Type: Fixed
• No. Of Outputs: 1
• Output Voltage: 15V
• Output Current: 1.5A
• Power Rating: 22.5W
• Input Voltage: 90V AC To 264V AC
• Length: 124mm
• Width: 101mm
• Height: 41mm
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• 3rd Output: -
• 2nd Output: -
• 4th Output: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: HSB151.5

7) AC fuse
8) External Overvoltage Protectors (OVP12 module)
Apply L & N to:
For use at:
Jumper(s)
An external fuse (see ratings table) should be installed. Use a 125VAC or higher
rated fuse for 100-120VAC operation, and a 250VAC fuse for 220-240VAC
operation. Fuse type should be anti-surge.
In general most 5V output H Series power supplies come with internal Over Voltage
Protection. If OVP is required on other voltage outputs, then an external OVP
module should be fitted as follows:
The OVP module is user adjustable from approximately 6.2V to 34V.
The maximum current rating of the OVP12 module is 12A peak, 8A continuous.
The recommended trigger voltages are
The above table indicates Lambda’s recommended level set point for different output
voltages. Where +/- outputs exist with a common terminal, a single OVP module
located across the + and – terminals will provide functional OVP for both individual
outputs.
The OVP module comes complete with mounting hardware and hookup leads. To
connect the OVP to your supply, see your power supply’s user’s manual for
recommended placement or Lambda’s website
supply outline drawing. See example below
Nominal Output Voltage
1 - 3, 2 - 4
100VAC
AC INPUT & JUMPER INFORMATION
1 - 5
Dual +/-12V
Dual +/-15V
12V
15V
24V
5V
LAMBDA
1 – 3, 2 - 4
120VAC
1 – 4
HSeries
Suggested Trip Point
www.lambda.com
6.2 +/-0.4V
220VAC
14V
17V
27V
27V
33V
2 - 3
1 - 5
for the power
230/240VAC
2 - 3
1 - 4