ENFIS UNO PLUS ARRAY RED Enfis, ENFIS UNO PLUS ARRAY RED Datasheet - Page 2

• Manufacturer Part Number: ENFIS UNO PLUS ARRAY RED
• Description: LED ARRAY UNO PLUS 620NM RED
• Manufacturer: Enfis
• Type: With Connectorr

Specifications of ENFIS UNO PLUS ARRAY RED

• Color: Red
• Luminous Flux @ Current - Test: 900 lm
• Current - Test: 2A
• Current - Max: 2A
• Driver Circuitry: No
• Voltage: 25V
• Wavelength: 620nm
• Configuration: Square
• With Connector: Yes
• Voltage - Input: 25V
• Power - Input: 50W
• Led Color: Red
• Wavelength Typ: 630nm
• Luminous Flux @ Test: 900lm
• Supply Voltage: 25V
• Forward Current @ Test: 2A
• Power Rating: 50W
• Peak Wavelength: 630nm
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Interface: -
• Other names: 722-1065; ENFIS UNO PLUS PCB ARRAY RED

All measurements performed at a heatsink temperature of 25°C
Uno Plus Array Red 630nm Rev 5 July 08
Technical Specification
Electro-Optical Characteristics
Heat Generation
Proper thermal design of the end product is of
paramount importance. The operational junction
temperature of each LED chip should be kept below
125°C.
Please contact Enfis for further support in this
matter.
Handling LED Array
Contact with the encapsulation on the surface of the
LED array must be avoided to prevent damage.
Do not apply pressure to the encapsulation or allow
it to come into contact with sharp objects.
During operation the encapsulation will be hot and
contact should be avoided
Static Electricity
Care must be taken when handling,
these products are sensitive to static
electricity .
Observe static handling precautions.
Item
Rated Current
If (mA)
Forward Voltage
Vf (Volts)
Peak Wavelength
λp (nm)
Dominant Wavelength
λd (nm)
Spectral Width
Δλ (nm)
Total Radiant Flux
ΦR (mW)
Radiant Flux Density
ΦR/A (mW/cm
Total Luminous Flux
ΦL (Lumens)
Luminous Flux Density
ΦL/A (lm/cm
Total Electrical Power
P (W)
2
)
2
)
ENFIS UNO Plus Array Red 630nm
3480
4000
Min
620
610
696
800
12
20
2000
5000
4350
Typ
630
620
900
783
25
16
50
Max
640
630
30
22
Cleaning
Avoid touching the LED array surface.
To clean—BLOW surface with either dry air or
nitrogen gas
Eye Safety Precautions
The light output of the products may cause injuries
to
products are viewed directly with unshielded eyes
for more than a few seconds.
Please refer to IEC 60825-1:2001 for
further information
human
ENFIS LIMITED
Technium 2, Kings Road,
Swansea Waterfront,
Swansea, SA18PJ, UK
Tel [phone]
Fax [phone]
www.enfis.com
[e-mail]
eyes
in
circumstances
where
the