TRX10GVP2010 FCI, TRX10GVP2010 Datasheet - Page 9

• Manufacturer Part Number: TRX10GVP2010
• Description: TXRX OPT SFP+ SR 10GB/S 850NM
• Manufacturer: FCI

Specifications of TRX10GVP2010

• Data Rate: 10Gbps
• Wavelength: 850nm
• Applications: Ethernet
• Voltage - Supply: 3.1 V ~ 3.5 V
• Connector Type: LC Duplex
• Mounting Type: SFP+
• Data Rate Max: 11.3Gbps
• Supply Voltage: 3.3V
• Wavelength Typ: 850nm
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 827-1000

Product Specification
10GBd SFP+ 850nm Limiting Transceiver TRX10GVP2010
calibrated internally; there is no need for external post processing.
Temperature
Internally measured temperature data is represented as two’s complement of a signed 16-bit value in
increments of 1/256 °C over a range of -40 to +100°C. Accuracy is better than +/-3%.
Supply Voltage (VCC)
Internally measured supply voltage. Represented as a 16-bit unsigned integer with the voltage defined as the
full 16 bit value (0 – 65535) with LSB equal to 100 Volt, which yields to a total range of 0 to +6.55 Volts.
Accuracy is better than +/-3%.
Laser Bias Current
The VCSEL bias current is represented as a 16 bit unsigned integer with the current defined as the full 16-bit
value (0 – 65535) with LSB equal to 2 A, valid range is 0 to 20 mA. Accuracy is better than +/-10%.
Optical Transmitter Power
TX output power measurement is based on internal monitor diode feedback. Represented as a 16-bit
unsigned integer with the power defined as the full 16 bit value (0 – 65535) with LSB equal to 0.1 W.
Accuracy is better than +/-3dB over a range of Pav
Communication is done by a serial 2-wire interface compatible to the I2C bus protocol. Refer to SFF-8472 for
a more detailed register explanation of the registers:
Digital Optical Monitoring
The transceiver offers the ability to monitor important module parameter during operation. All five parameters
listed below are continuously monitored for getting information about the current module status. All data is
Receiver Optical Power
RX input power measurement is based on photodiode diode current. Represented as a 16-bit unsigned
integer with the power defined as the full 16 bit value (0 – 65535) with LSB equal to 0.1 W. Accuracy is
better than +/-3dB over a range of -12dBm to -1dBm.
Note: The specified characteristics are met within the recommended range of operating conditions regarding temperature and voltage.
INTERFACING THE TRANSCEIVER
128 - 255
Register
96 - 127
0 - 95
www.fciconnect.com
Base Address A0h
Serial Transceiver ID as
MergeOptics Specific
defined in SFP MSA
Reserved
Content
min
TRX10GVP2010 Datasheet, Rev. B04, July 2010
to Pav
max
120 – 127
128 – 247
248 - 255
Register
96 – 119
.
56 - 95
0 - 55
Base Address A2h
Customer specific, writable
Values from real time
diagnostic monitoring
constants (not used)
Thresholds & Limits
External calibration
Alarm & Warnings
Not used
Not used
Content
area
9