F-51320GNY-LY-AA Optrex America Inc, F-51320GNY-LY-AA Datasheet - Page 22

• Manufacturer Part Number: F-51320GNY-LY-AA
• Description: LCD GRAPH MOD 128X64 COG YLW LED
• Manufacturer: Optrex America Inc
• Series: F-51320r

Specifications of F-51320GNY-LY-AA

• Display Type: LCD - Monochrome
• Display Mode: Transflective
• Viewing Area: 66.80mm L x 35.50mm W
• Backlight: LED - Yellow/Green
• Dot Size: 0.48mm W x 0.48mm H
• Dot Pitch: 0.50mm x 0.50mm
• Dot Pixels: 128 x 64
• Interface: Parallel
• Other names: 73-1220

The Following precautions will guide you in handling our product correctly.
10. Precautions Relating Product Handling
1) Liquid crystal display devices
2) Care of the liquid crystal display module against static electricity discharge.
3) When the LCD module alone must be stored for long periods of time:
4) Use the module with a power supply that is equipped with an overcurrent protector circuit,
5) Do not ingest the LCD fluid itself should it leak out of a damaged LCD module. Should hands or
6) Conduc1tivity is not guaranteed for models that use metal holders where solder connections
7) For models which use CFL:
8) For models which use touch panels:
9) For models which use COG,TAB,or COF:
1. The liquid crystal display device panel used in the liquid crystal display module is made of
2. The polarizer adhering to the surface of the LCD is made of a soft material.
2. Avoid the use of work clothing made of synthetic fibers. We recommend cotton clothing or
3. Slowly and carefully remove the protective film from the LCD module, since this operation can
1. Protect the modules from high temperature and humidity.
2. Keep the modules out of direct sunlight or direct exposure to ultraviolet rays.
3. Protect the modules from excessive external forces.
1. High voltage of 1000V or greater is applied to the CFL cable connector area.
2. Protect CFL cables from rubbing against the unit and thus causing the wire jacket to become
3.The use of CFLs for extended periods of time at low temperatures will significantly shorten
1.Do not stack up modules since they can be damaged by components on neighboring
2.Do not place heavy objects on top of the product. This could cause glass breakage.
1.The mechanical strength of the product is low since the IC chip faces out unprotected from
2.Given the fact that the rear of the IC chip is left exposed, in order to protect the unit from
F-51320GNY-LY-AA (AA) No. 2001-0047
1. When working with the module, be sure to ground your body and any electrical equipment you
since the module is not provided with this protective feature.
between the metal holder and the PCB are not used. Please contact us to discuss appropriate
ways to assure conductivity.
clothing come in contact with LCD fluid, wash immediately with soap.
Care should be taken not to touch connection areas to avoid burns.
their service life.
modules.
the rear.
Be sure to protect the rear of the IC chip from external forces.
electrical damage, avoid installation configurations in which the rear of the IC chip runs the
risk of making any electrical contact.
plate glass. Avoid any strong mechanical shock. Should the glass break handle it with care
Guard against scratching it.
may be using. We strongly recommend the use of anti static mats ( made of rubber ), to
protect work tables against the hazards of electrical shock.
other conductivity-treated fibers.
generate static electricity.
worn.
OPTREX CORPORATION
Page 22/23