DMF-5010NBU-FW-BD Optrex America Inc, DMF-5010NBU-FW-BD Datasheet - Page 18

• Manufacturer Part Number: DMF-5010NBU-FW-BD
• Description: LCD GRAPHIC MODULE 240X64 PIXEL
• Manufacturer: Optrex America Inc
• Series: DMF-5010r

Specifications of DMF-5010NBU-FW-BD

• Display Type: LCD - Monochrome
• Display Mode: Transflective
• Viewing Area: 132.00mm L x 39.00mm W
• Backlight: CCFL - White
• Dot Size: 0.49mm W x 0.49mm H
• Dot Pitch: 0.53mm x 0.53mm
• Dot Pixels: 240 x 64
• Interface: Parallel
• Other names: 73-1132; DMF-5010NBU-FW; DMF5010NBU-FW; DMF5010NBUFW; OP150NBUFW

The Following precautions will guide you in handling our product correctly.
DMF5010NBU-FW (AB) No.2000-00153
10.Precautions Relating Product Handling
1) Liquid crystal display devices
2) Care of the liquid crystal display module against static electricity discharge.
3) When the LCD module alone must be stored for long periods of time:
4) Use the module with a power supply that is equipped with an overcurrent protector circuit,
5) Do not ingest the LCD fluid itself should it leak out of a damaged LCD module. Should hands
6) Conduc1tivity is not guaranteed for models that use metal holders where solder connections
7) For models which use CFL:
① The liquid crystal display device panel used in the liquid crystal display module is made of plate
② The polarizer adhering to the surface of the LCD is made of a soft material.
① When working with the module, be sure to ground your body and any electrical equipment you may
② Avoid the use of work clothing made of synthetic fibers. We recommend cotton clothing or other
③ Slowly and carefully remove the protective film from the LCD module, since this operation can
① Protect the modules from high temperature and humidity.
② Keep the modules out of direct sunlight or direct exposure to ultraviolet rays.
③ Protect the modules from excessive external forces.
① High voltage of 1000V or greater is applied to the CFL cable connector area.
② Protect CFL cables from rubbing against the unit and thus causing the wire jacket to become worn.
③ The use of CFLs for extended periods of time at low temperatures will significantly shorten their
or clothing come in contact with LCD fluid, wash immediately with soap.
between the metal holder and the PCB are not used. Please contact us to discuss appropriate
since the module is not provided with this protective feature.
ways to assure conductivity.
glass. Avoid any strong mechanical shock. Should the glass break handle it with care.
Care should be taken not to touch connection areas to avoid burns.
be using. We strongly recommend the use of anti static mats ( made of rubber ), to protect work
tables against the hazards of electrical shock.
generate static electricity.
Guard against scratching it.
service life.
conductivity-treated fibers.
OPTREX
OPTREX CORPORATION
Page 18/19