T-55466D084J-LW-A-AAN Optrex America Inc, T-55466D084J-LW-A-AAN Datasheet - Page 24

• Manufacturer Part Number: T-55466D084J-LW-A-AAN
• Description: LCD 8.4" TFT MOD 800X600 SVGA
• Manufacturer: Optrex America Inc

Specifications of T-55466D084J-LW-A-AAN

• Display Type: TFT- Thin Film Transistor
• Display Mode: Transmissive
• Viewing Area: 170.40mm L x 127.80mm W
• Backlight: LED - White
• Dot Pitch: 0.21mm x 0.21mm
• Dot Pixels: 800 x 600 (SVGA)
• Interface: LVDS
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Dot Size: -
• Lead Free Status / Rohs Status: Details

(3) PRECAUTIONS WITH ELECTROSTATICS
(4) STORAGE PRECAUTIONS
(5) SAFETY PRECAUTIONS
(2) OPERATING PRECAUTIONS
LCD should be stored in the room temperature environment with normal humidity. The LCD
inventory should be processed by first-in first-out method.
i. Please connect the metal frame of LCD module to GND in order to minimize the effect of
a. When you waste damaged or unnecessary LCDs, it is recommended to crush LCDs into pieces
j. Be sure to connect the cables and the connecters correctly.
a. This LCD module use CMOS-IC on circuit board and TFT-LCD panel, and so it is easy to be
b. Please remove protection film very slowly from the surface of LCD module to prevent from
b. If any liquid leaks out of a damaged glass cell and comes in contact with the hands, wash off
c. Be sure to turn off the power supply when inserting or disconnecting the LED backlight cable.
a. Please be sure to turn off the power supply before connecting and disconnecting signal input
b. Please do not change variable resistance settings in LCD module. They are adjusted to the
c. The interface signal speed is very high. Please pay attention to transmission line design and
d. A condensation might happen on the surface and inside of LCD module in case of sudden
e. Please pay attention not to display the same pattern for very long time. Image might stick on
f. Please obey the same safe instructions as ones being prepared for ordinary electronic products.
OPTREX
and wash them off with solvents such as acetone and ethanol, which should later be burned.
thoroughly with soap and water.
cable.
most suitable value. If they are changed, it might happen LCD does not satisfy the
characteristics specification.
other high speed signal precautions to satisfy signal specification.
change of ambient temperature. Please take care so as not to cause any damage mentioned on
(1)-d.
LCD. Even if image sticking happens, it may disappear as the operation time proceeds.
affected by electrostatics. Please be careful with electrostatics by the way of your body
connecting to the ground and so on.
external noise and EMI.
electrostatics occurrence.
Confidential
(24/25)
T-55466D084J-LW-A-AAN