STCC2 Stanley Electric Co, STCC2 Datasheet - Page 4

• Manufacturer Part Number: STCC2
• Description: CONN MOD COUPLER W/SGL CABLE
• Manufacturer: Stanley Electric Co
• Series: S-Typer

Specifications of STCC2

• Accessory Type: Module Coupler w/single wires
• For Use With/related Products: Slim Stick Modules
• For Use With: 404-1185 - LED SLIM STICK 15LEDS WARM WHITE404-1184 - LED SLIM STICK 15LEDS COOL WHITE404-1183 - LED SLIM STICK 30LEDS WARM WHITE404-1182 - LED SLIM STICK 30LEDS COOL WHITE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 404-1188

● ● ● ● When washers are used:
● ● ● ● When plates are used:
3. INSTALLATION, CONNECTION
Two or more Slim Stick S LED modules can be installed by joining them with special couplers. A heat sink
mounted LED module has superior reliability.
● ● ● ●
(1) Installation with screws
(2) Installation with double-faced tape
Pay attention not to warp the Slim Stick S-Type while installing. A warped installation will
have shorter LED module life and low reliability.
When the special BJB connector is used for coupling LD modules, a 2mm gap will exist due
to the coupler's thickness. To remedy this, a plate, washer or spacer of 2mm thickness must
be used to mount the LED module with bolt.
BJB coupler
Installation Procedure
30 LEDs (STW0101N, STN0101N)
15 LEDs (STW0201N, STN0201N)
Use M3 bolts (round head diameter < 0.7mm) for mounting LED module.
The LED module is equipped with one guide hole. Use this hole for positioning the LED module.
There are five mounting holes in addition to the guide hole. At least two holes must be secured with bolts.
The LED modules can be installed with double-faced tape. (Recommended tape: NITTO 5000N)
[NOTE] In the case of 30 LED types (STW0101N, STN0101N), pay attention that the holes' line is
WARNING
offset from the LEDs' line.
Guide hole
Guide hole
Screw
PWB
3
If the screw is secured without the above
spacer, the LED module will warp 2mm
stressing the part.
＊ When a metal plate is used, the insulator must
Plates (Thickness: 2mm)
be placed between the back of the circuit board
and the metal plate. Apply the appropriate
insulator such as vinyl tape to the metal plate.
Washers (Thickness: 2mm)
Offset : 0.7mm