MD1170-D512 SanDisk, MD1170-D512 Datasheet - Page 12
![IDOC 512MB 40-IDE RIGHT](/photos/7/82/78292/md1170-d_series_back_sml.jpg)
MD1170-D512
Manufacturer Part Number
MD1170-D512
Description
IDOC 512MB 40-IDE RIGHT
Manufacturer
SanDisk
Datasheet
1.MD1160-D32.pdf
(23 pages)
Specifications of MD1170-D512
Memory Size
512MB
Memory Type
FLASH - Nand
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Other names
585-1075
4.3
iDiskOnChip can be connected to the host by placing it directly on the on-board socket. If a cable is
used, it should be no longer than 18 inches, and should be aligned as follows:
For 44-pin iDiskOnChip:
•
•
For 40-pin iDiskOnChip:
•
•
The 40-pin iDiskOnChip version has a separate connector for the power supply, to which a power
supply cable can be connected. In addition, pin 20 can also be used for power supply connections.
Please refer to the pin description for further details.
Note: For a list of recommended connectors, contact an M-Systems representative.
4.4
If iDiskOnChip is being installed as an additional IDE drive using the same IDE I/O port, jumper J1
must be set to indicate that this drive is a slave. The default is master with no jumpers. Table 3
shows the J1 jumper settings for iDiskOnChip operation in Master and Slave mode.
4.4.1 Vertical Configuration
The vertical configuration can operate in either Master or Slave mode. The following figures show
the jumper settings for the iDiskOnChip vertical configuration.
12
Figure 8: Master Setting for Vertical iDiskOnChip
Figure 6: Slave Setting for Vertical iDiskOnChip
Pin 1 of the cable must be aligned with pin 1 of the iDiskOnChip connector.
Pin 44 of the cable must be aligned with pin 44 of the iDiskOnChip connector.
Pin 1 of the cable must be aligned with pin 1 of the iDiskOnChip connector.
Pin 40 of the cable must be aligned with pin 40 of the iDiskOnChip connector.
Electrical Connections for iDiskOnChip
Installing iDiskOnChip in a Two-Drive Configuration (Master/Slave)
No jumper is installed (open)
44-Pin Connector
44-Pin Connector
Jumper is installed (short)
J1 Jumper Settings
Table 3: Jumper Settings for Master/Slave Mode
iDiskOnChip (iDOC) Data Sheet, Rev. 1.2
Figure 9: Master Setting for Vertical iDiskOnChip
Figure 7: Slave Setting for Vertical iDiskOnChip
Operation Mode
40-Pin Connector
40-Pin Connector
Master
Slave
91-SR-012-01-8L