ACPL-074L-060E Avago Technologies US Inc., ACPL-074L-060E Datasheet - Page 5

• Manufacturer Part Number: ACPL-074L-060E
• Description: OPTOCOUPLER DUAL 15MBD 8-SOIC
• Manufacturer: Avago Technologies US Inc.

Specifications of ACPL-074L-060E

• Package / Case: 8-SOIC (0.154", 3.90mm Width)
• Voltage - Isolation: 3750Vrms
• Number Of Channels: 2, Unidirectional
• Current - Output / Channel: 10mA
• Data Rate: 15MBd
• Propagation Delay High - Low @ If: 29ns @ 14mA
• Current - Dc Forward (if): 20mA
• Input Type: DC
• Output Type: Push-Pull, Totem-Pole
• Mounting Type: Surface Mount
• Isolation Voltage: 3750 Vrms
• Maximum Continuous Output Current: 10 mA
• Maximum Fall Time: 25 ns
• Maximum Forward Diode Current: 20 mA
• Maximum Rise Time: 20 ns
• Minimum Forward Diode Voltage: 1.3 V
• Output Device: Logic Gate Photo IC
• Configuration: 2 Channel
• Maximum Baud Rate: 15 MBps
• Maximum Forward Diode Voltage: 1.8 V
• Maximum Operating Temperature: + 105 C
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

Insulation and Safety Related Specifications
All Avago Technologies data sheets report the creepage
and clearance inherent to the optocoupler component it-
self. These dimensions are needed as a starting point for
the equipment designer when determining the circuit
insulation requirements. However, once mounted on a
printed circuit board,
ance requirements must be met as specified for individual
equipment standards. For creepage, the shortest distance
5
Parameter
Minimum External Air
Gap (Clearance)
Minimum External
Tracking (Creepage)
Minimum Internal Plastic
Gap (Internal Clearance)
Tracking Resistance
(Comparative Tracking Index)
Isolation Group
minimum creepage and clear-
Symbol
L(I01)
L(I02)
CTI
Value
4.9
4.8
0.08
≥175
IIIa
Units
mm
mm
mm
Volts
path along the surface of a printed circuit board between
the solder fillets of the input and output leads must be
considered. There are recommended techniques such as
grooves and ribs which may be used on a printed circuit
board to achieve desired creepage and clearances. Creep-
age and clearance distances will also change depending
on factors such as pollution degree and insulation level.
Conditions
Measured from input terminals to output terminals,
shortest distance through air.
Measured from input terminals to output terminals,
shortest distance path along body.
Insulation thickness between emitter and detector;
also known as distance through insulation.
DIN IEC 112/VDE 0303 Part 1
Material Group (DIN VDE 0110, 1/89, Table 1)