HCPL-3140#300 Avago Technologies US Inc., HCPL-3140#300 Datasheet - Page 11

• Manufacturer Part Number: HCPL-3140#300
• Description: OPTOCOUPLER 1CH 0.4A 8-SMD GW
• Manufacturer: Avago Technologies US Inc.

Specifications of HCPL-3140#300

• Package / Case: 8-SMD Gull Wing
• Voltage - Isolation: 3750Vrms
• Number Of Channels: 1, Unidirectional
• Current - Output / Channel: 600mA
• Propagation Delay High - Low @ If: 300ns @ 8mA
• Current - Dc Forward (if): 25mA
• Input Type: DC
• Output Type: Push-Pull, Totem-Pole
• Mounting Type: Surface Mount, Gull Wing
• Isolation Voltage: 3750 Vrms
• Maximum Fall Time: 50 ns
• Maximum Forward Diode Current: 25 mA
• Maximum Rise Time: 50 ns
• Minimum Forward Diode Voltage: 1.2 V
• Output Device: Logic Gate Photo IC
• Configuration: 1 Channel
• Maximum Forward Diode Voltage: 1.8 V
• Maximum Reverse Diode Voltage: 5 V
• Maximum Power Dissipation: 250 mW
• Maximum Operating Temperature: + 100 C
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

CONTROL
Applications Information
Eliminating Negative IGBT Gate
Drive
To keep the IGBT firmly off,
the HCPL-3140/HCPL-0314 has a
very low maximum V
specification of 1.0 V. Minimizing
Rg and the lead inductance from
the HCPL-3140/HCPL-0314 to
the IGBT gate and emitter
(possibly by mounting the
Figure 19. Recommended LED drive and application circuit for HCPL-3140/HCPL-0314.
11
COLLECTOR
INPUT
+5 V
74XXX
OPEN
270
OL
1
2
3
4
HCPL-3140/HCPL-0314
HCPL-3140/HCPL-0314 on a
small PC board directly above the
IGBT) can eliminate the need for
negative IGBT gate drive in many
applications as shown in
Figure 19. Care should be taken
with such a PC board design to
avoid routing the IGBT collector
or emitter traces close to the
HCPL-3140/HCPL-0314 input as
this can result in unwanted
8
7
6
5
0.1 µF
+
–
V
CC
Rg
= 15 V
Q1
Q2
coupling of transient signals into
the input of HCPL-3140/
HCPL-0314 and degrade
performance. (If the IGBT
drain must be routed near the
HCPL-3140/HCPL-0314 input,
then the LED should be reverse
biased when in the off state, to
prevent the transient signals
coupled from the IGBT drain
from turning on the HCPL-3140/
HCPL-0314.)
3-PHASE
+ HVDC
- HVDC
AC