HCPL-2400-300E Avago Technologies US Inc., HCPL-2400-300E Datasheet - Page 15

• Manufacturer Part Number: HCPL-2400-300E
• Description: ISOLAT 3.75KVRMS 1CH UNIDIR 8SMD
• Manufacturer: Avago Technologies US Inc.

Specifications of HCPL-2400-300E

• Package / Case: 8-SMD Gull Wing
• Voltage - Isolation: 3750Vrms
• Number Of Channels: 1, Unidirectional
• Current - Output / Channel: 25mA
• Data Rate: 40MBd
• Propagation Delay High - Low @ If: 33ns @ 7mA
• Current - Dc Forward (if): 10mA
• Input Type: DC
• Output Type: Tri-State
• Mounting Type: Surface Mount, Gull Wing
• Isolation Voltage: 3750 Vrms
• Maximum Continuous Output Current: 25 mA
• Maximum Fall Time: 0.01 us
• Maximum Forward Diode Current: 10 mA
• Minimum Forward Diode Voltage: 1.1 V
• Output Device: Logic Gate Photo IC
• Configuration: 1 Channel
• Maximum Baud Rate: 40 MBd(Typ)
• Maximum Forward Diode Voltage: 1.5 V
• Maximum Reverse Diode Voltage: 2 V
• Maximum Power Dissipation: 350 mW
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: 0 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 516-1656-5

Switching performance of the HCPL-2400/30 optocou-
plers is not sensitive to the TTL logic family used in the
recommended drive circuit. The typical and worst-case
switching parameters given in the data sheet can be
met using common 74LS TTL inverting gates or buffers.
Use of faster TTL families will slightly reduce the overall
propagation delays from the input of the drive circuit to
For product information and a complete list of distributors, please go to our website:
Avago, Avago Technologies, and the A logo are trademarks of Avago Technologies Limited in the United States and other countries.
Data subject to change. Copyright © 2007 Avago Technologies Limited. All rights reserved. Obsoletes AV01-0563EN
AV02-0962EN - January 4, 2008
www.avagotech.com
the output of the optocoupler, but will not necessarily
result in lower pulse-width distortion or propagation de-
lay skew. This reduction in overall propagation delay is
due to shorter delays in the drive circuit, not to changes
in the propagation delays of the optocoupler; optocou-
pler propagation delays are not affected by the speed of
the logic used in the drive circuit.