TRAC020LHQ36 Diodes Zetex, TRAC020LHQ36 Datasheet - Page 5

• Manufacturer Part Number: TRAC020LHQ36
• Description: IC TRAC ANA 5V 5MA 20CELL 36QSOP
• Manufacturer: Diodes Zetex

Specifications of TRAC020LHQ36

• Applications: *
• Mounting Type: Surface Mount
• Package / Case: 36-QSOP
• For Use With: TRAC020LHEURO - TRAC DEVELOPMENT KIT EUROPE
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

DESCRIPTION OF PIN FUNCTIONS
DATA
RESET
PD
CLOCK
DOUT
CLCR
IO3..IO22
IO1,IO2
V
A
V
DD
GND
SS
Serial programming data is input to the TRAC via this pin. Each TRAC cell contains
a 3-bit shift register that allows each cell to be programmed to the required analog
function.
Active low - The pin resets all on-chip shift registers to the logic zero state, which sets
all TRAC cells to the OFF function. The pin should be held high while the device is
being programmed and when the analog functions are in use.
off the supply current to all the TRAC cells. This does not influence the programming
of the cells so this feature can be used to reduce power consumption for applications
that have a standby mode. The pin should be held high while the device is being
programmed and when the analog functions are in use. This pin is permanently held
high (V
Used to clock in the serial data to program the TRAC device. The on-chip shift registers
are positive edge triggered.
This pin is the serial data output from cell 20 on the TRAC device. This is used for
validation of programming of the TRAC device. This pin also allows two or more
TRAC devices to be connected in a serial architecture. This is done by connecting the
DOUT pin of the first TRAC device to the DATA pin of the second TRAC device, and
connecting the CLOCK pins.
Clock Clear. When the TRAC device is used in stand alone applications CLCR is used
as a control pin. It allows the downloading circuitry to be switched off when the
programming serial data from the EEPROM is complete.
These are the analog inputs / outputs for cells 1 to 20.
These are the analog inputs for cells 1 and 2.
TRAC positive supply rail (+3V)
Analog Ground
TRAC negative supply rail (-2V) - this will also be the system ground
Active low - The pin switches off the bias generators to the analog cells, which turns
DD
) on the TRAC development board.
5
TRAC020LH