LM2575N-5.0/NOPB National Semiconductor, LM2575N-5.0/NOPB Datasheet - Page 12

• Manufacturer Part Number: LM2575N-5.0/NOPB
• Description: IC REG SIMPLE SWITCHER 16-DIP
• Manufacturer: National Semiconductor
• Series: SIMPLE SWITCHER®r
• Type: Step-Down (Buck)r

Specifications of LM2575N-5.0/NOPB

• Internal Switch(s): Yes
• Synchronous Rectifier: No
• Number Of Outputs: 1
• Voltage - Output: 5V
• Current - Output: 1A
• Frequency - Switching: 52kHz
• Voltage - Input: 4 ~ 40 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Through Hole
• Package / Case: 16-DIP (0.300", 7.62mm)
• Current, Input Bias: 50 nA
• Current, Output: 1 A
• Current, Supply: 10 mA
• Frequency, Oscillator: 52 kHz
• Package Type: DIP-16
• Regulator Type: Buck (Step-Down)
• Temperature, Operating, Range: -40 to +125 °C
• Voltage, Input: 40 V
• Voltage, Output: 5 V
• Primary Input Voltage: 12V
• No. Of Outputs: 1
• Output Voltage: 5V
• Output Current: 1A
• No. Of Pins: 16
• Operating Temperature Range: -40°C To +125°C
• Msl: MSL 1 - Unlimited
• Input Voltage Primary Max: 40V
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Power - Output: -
• Lead Free Status / Rohs Status: RoHS Compliant part Electrostatic Device
• Other names: *LM2575N-5.0; *LM2575N-5.0/NOPB; LM2575N-5.0

www.national.com
Test Circuit and Layout Guidelines
As in any switching regulator, layout is very important. Rapidly
switching currents associated with wiring inductance gener-
ate voltage transients which can cause problems. For minimal
inductance and ground loops, the length of the leads indicated
C
C
D1 — Schottky, 11DQ06
L1 — 330 μH, PE-52627 (for 5V in, 3.3V out, use 100 μH, PE-92108)
where V
R1 — 2k, 0.1%
R2 — 6.12k, 0.1%
Note: Pin numbers are for the TO-220 package.
IN
OUT
— 100 μF, 75V, Aluminum Electrolytic
— 330 μF, 25V, Aluminum Electrolytic
REF
= 1.23V, R1 between 1k and 5k.
Adjustable Output Voltage Version
Fixed Output Voltage Versions
FIGURE 2.
12
by heavy lines should be kept as short as possible. Single-
point grounding (as indicated) or ground plane construction
should be used for best results. When using the Adjustable
version, physically locate the programming resistors near the
regulator, to keep the sensitive feedback wiring short.
1147508
1147509