LM2594M-ADJ/NOPB National Semiconductor, LM2594M-ADJ/NOPB Datasheet - Page 25

• Manufacturer Part Number: LM2594M-ADJ/NOPB
• Description: IC REG SIMPLE SWITCHER 8-SOIC
• Manufacturer: National Semiconductor
• Series: SIMPLE SWITCHER®r
• Type: Step-Down (Buck)r

Specifications of LM2594M-ADJ/NOPB

• Internal Switch(s): Yes
• Synchronous Rectifier: No
• Number Of Outputs: 1
• Voltage - Output: 1.2 ~ 37 V
• Current - Output: 500mA
• Frequency - Switching: 150kHz
• Voltage - Input: 4.5 ~ 40 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC (3.9mm Width)
• Primary Input Voltage: 60V
• No. Of Outputs: 1
• Output Voltage: 37V
• Output Current: 500mA
• No. Of Pins: 8
• Operating Temperature Range: -40°C To +125°C
• Msl: MSL 1 - Unlimited
• Rohs Compliant: Yes
• Current, Input Bias: 10 nA
• Current, Output: 0.5 A
• Current, Supply: 5 mA
• Frequency, Oscillator: 150 kHz
• Package Type: SOIC
• Regulator Type: Buck (Step-Down)
• Temperature, Operating, Range: -40 to +125 °C
• Voltage, Input: 4.5 to 40 V
• Voltage, Output: 1.2 to 37 V
• Peak Reflow Compatible (260 C): Yes
• Termination Type: SMD
• Filter Terminals: SMD
• Input Voltage: 40V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Power - Output: -
• Lead Free Status / Rohs Status: RoHS Compliant part Electrostatic Device
• Other names: *LM2594M-ADJ; LM2594M-ADJ

Application Information
put reaches its nominal output voltage. The actual time de-
pends on the output voltage and the size of the output
capacitor. Input power sources that are current limited or
sources that can not deliver these currents without getting
loaded down, may not work correctly. Because of the rela-
tively high startup currents required by the inverting topology,
the delayed startup feature (C1, R
25 is recommended. By delaying the regulator startup, the
input capacitor is allowed to charge up to a higher voltage
before the switcher begins operating. A portion of the high in-
put current needed for startup is now supplied by the input
capacitor (C
pacitor can be made much larger than normal.
IN
). For severe start up conditions, the input ca-
FIGURE 28. Inverting Regulator Ground Referenced Shutdown using Opto Device
FIGURE 27. Inverting Regulator Ground Referenced Shutdown
1
and R
(Continued)
2
) shown in Figure
25
INVERTING REGULATOR SHUTDOWN METHODS
To use the ON /OFF pin in a standard buck configuration is
simple, pull it below 1.3V (
turn regulator ON, pull it above 1.3V to shut the regulator
OFF. With the inverting configuration, some level shifting is
required, because the ground pin of the regulator is no
longer at ground, but is now setting at the negative output
voltage level. Two different shutdown methods for inverting
regulators are shown in Figure 27 and Figure 28 .
DS012439-42
@
25˚C, referenced to ground) to
DS012439-43
www.national.com