AD7414ART-0REEL Analog Devices Inc, AD7414ART-0REEL Datasheet - Page 4

• Manufacturer Part Number: AD7414ART-0REEL
• Description: IC SENSOR TEMP 10BIT SOT23-6 TR
• Manufacturer: Analog Devices Inc

Specifications of AD7414ART-0REEL

• Rohs Status: RoHS non-compliant
• Function: Temp Monitoring System (Sensor)
• Topology: ADC, Comparator, Register Bank
• Sensor Type: Internal
• Sensing Temperature: -40°C ~ 125°C
• Output Type: I²C™/SMBus™
• Output Alarm: No
• Output Fan: No
• Voltage - Supply: 2.7 V ~ 5.5 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: SOT-23-6

AD7414/AD7415
Parameter
AC ELECTRICAL CHARACTERISTICS
1
2
3
4
5
6
7
8
9
Accuracy specifications apply only to voltages listed under Test Conditions. See Temperature Accuracy vs. Supply section for typical accuracy performance over the
full V
100% production tested at 40°C to these limits.
These current values can be used to determine average power consumption at different one-shot conversion rates. Average power consumption at the automatic
conversion rate of 1.25 kHz is 940 μW.
This peak supply current is required for 29 μs (the conversion time plus power-up time) out of every 800 μs (the conversion rate).
These current values are derived by not issuing a stop condition at the end of a write or read, thus preventing the part from going into a conversion.
The current is derived assuming a 400 kHz serial clock being active continuously.
On power-up, the initial input current, I
The SDA and SCL timing is measured with the input filters turned on so as to meet the fast mode I
rate but has a negative effect on the EMC behavior of the part.
Guaranteed by design. Not tested in production.
Serial Clock Period, t
Data In Setup Time to SCL High, t
Data Out Stable after SCL Low, t
SDA Low Setup Time to SCL Low
SDA High Hold Time after SCL High
SDA and SCL Fall Time, t
Data Hold Time, t
Power-Up Time
(Start Condition), t
(Stop Condition), t
DD
supply range.
7
1
4
5
6
IN
3
8, 9
, on the AS pin is typically 50 μA.
2
DATA OUT
DATA IN
SDA
SDA
SCL
Figure 2. Diagram for Serial Bus Timing
t
4
A Version
2.5
50
0
50
50
90
35
4
Rev. F | Page 4 of 20
t
t
2
1
t
7
t
3
Unit
μs min
ns min
ns min
ns min
ns min
ns max
ns min
μs typ
2
C specification. Switching off the input filters improves the transfer
t
6
Test Conditions/Comments
See Figure 2
See Figure 2
See Figure 2
See Figure 2
See Figure 2
See Figure 2
See Figure 2
t
5