DS1780E+ Maxim Integrated Products, DS1780E+ Datasheet - Page 15
![IC CPU PERIPHERAL MON 24-TSSOP](/photos/6/56/65600/175-24-tssop_sml.jpg)
DS1780E+
Manufacturer Part Number
DS1780E+
Description
IC CPU PERIPHERAL MON 24-TSSOP
Manufacturer
Maxim Integrated Products
Datasheet
1.DS1780E.pdf
(28 pages)
Specifications of DS1780E+
Function
Thermal Monitor, CPU Peripherals
Topology
ADC (Sigma Delta), Comparator, Fan Speed Control, Register Bank
Sensor Type
Internal
Sensing Temperature
-40°C ~ 125°C
Output Type
I²C™/SMBus™
Output Alarm
No
Output Fan
Yes
Voltage - Supply
2.8 V ~ 5.75 V
Operating Temperature
-40°C ~ 125°C
Mounting Type
Surface Mount
Package / Case
24-TSSOP
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
OPERATION - Analog Output
The DS1780 has a single analog output from a unsigned 8-bit D/A which produces 0-1.25 volts; this is
amplified and scaled with external circuitry such as a op-amp and transistor to provide fan speed control.
This register is set to 0xFF on power-up, which produces full fan speed. The analog output register (19h)
is unaffected by any reset other than power-on.
This voltage must be scaled and have an output current of at least 250 mA which is needed to drive the
fans; Figure 6 is a simple circuit that can be used, and Table 9 suggest R1 and R2 to select gain.
Although it is recommended to connect the DS1780 analog output to a high impedance node such as that
in Figure 6, the output driver can source 2.0 mA (max) at V
of 5% of FSR over temperature and supply voltage. Stability is guaranteed for a load capacitance up to
100 pF. More capacitance could cause severe overshoots and possible oscillation.
FAN AMPLIFIER CIRCUIT EXAMPLE Figure 6
AMPLIFIER DESIGN EXAMPLES Table 9
OPERATION - NAND TREE Test
A NAND tree is provided in the DS1780 for Automated Test Equipment (ATE) board level connectivity
testing. If the user applies (V
A0/NT
NAND tree (see Figure 7 below) should be driven high.
Beginning with A1 and working around the chip, each pin can be toggled and a resulting toggle can be
observed on A0/NT
Allow for a typical propagation delay of 100 ns.
Input
Output
Gain
OUT
will become the NAND tree output pin. To perform a NAND tree test all pins included in the
OUT
.
10,000
1,000
2,200
3,300
4,700
R1
DD
- 0.5V) to the NT
15 of 28
IN
input, the device will be in the NAND tree test mode.
1.22
12
9.84
OUT
= 1.25V while maintaining the error spec
19,439
29,159
41,530
88,361
9,000
R2